Évaluations - 2, GPA: 4.5
(
)
)
|
Photos et spécifications Sony CFD-S350L |
Facilité d'utilisation
marked with or mark) must be used. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. • The sound may drop out or noise may be heard when using poor quality CD-Rs/CD- RWs or if there is a problem with the recording device or application software. Radio Reception is poor. • Reorient the aerial to improve FM reception. • Reorient the player itself to improve AM or MW/LW reception. The audio is weak or has poor quality. • Replace all the batteries with new ones if they are weak. • Move the player away from the TV. The picture of your TV becomes unstable. • If you are listening to an FM programme near the TV with an indoor aerial, move the player away from the TV. Frequency response TYPE I (normal): 80 - 10 000 Hz General Speaker Full range: 10 cm dia., 3.2 ., cone type (2) Outputs Headphones jack (stereo minijack): For 16 - 68 . impedance headphones Maximum Power output 5.2 W Power requirements For CD radio cassette-corder: Malaysia, Singapore and Thailand models: 230 - 240 V AC, 50Hz Korean model: 220 V AC, 60 Hz Other models: 230 V AC, 50 Hz 9 V DC, 6 R20 (size D) batteries For remote control: 3 V DC, 2 R03 (size AAA) batteries Power consumption AC 14 W Battery life For CD radio cassette-corder: FM recording Sony R20P: approx. 13.5 h Sony alkaline LR20: approx. 20 h Tape playback Sony R20P: approx. 7.5 h Sony alkaline LR20: approx. 15 h CD playback Sony R20P: approx. 2.5 h Sony alkaline LR20: approx. 7 h Power Sources C AB 1 to AC IN 2 to the mains Connect the mains lead A or insert six R20 (size D) batteries (not supplied) into the battery compartment B . Notes • Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. • To use the player on batteries, disconnect the mains lead from the player. • When you operate the player on batteries, you cannot turn on the player using the remote. Preparing the remote C Insert two R03 (size AAA) batteries (not supplied). Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. Location of controls Listening to the radioPlaying a CD Playing a tape Recording 1 Press RADIO BAND•AUTO PRESET until the band you want appears in the display (direct power-on). Each time you press the button, the indication changes as follows: CFD-S350: “FM” t “AM” CFD-S350L: “FM” t “MW” t “LW” 2 Hold down TUNE + or – until the frequency digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press the button repeatedly to change the frequency step by step. Tip If the FM broadcast is noisy, press MODE repeatedly until “Mono” appears in the display and the radio will play in monaural. Changing the AM/MW tuning interval The AM/MW tuning interval is preset to 9 kHz at the factory. If you need to change the AM/MW tuning interval, do the following: 1 While keeping the RADIO BAND•AUTO PRESET button and TAPE button pressed, disconnect the mains lead from the mains. 2 While keeping the RADIO BAND•AUTO PRESET button and TAPE button pressed, reconnect the mains lead to the mains. The tuning interval is changed and “AM 9” “MW 9” or “AM 10” “MW 10” appears in the display for 2 seconds. After changing the tuning interval, you need to reset your preset radio stations. Presetting radio stations You can store radio stations into the player’s memory. You can preset up to 30 radio stations (CFD-S350), 20 for FM and 10 for AM in any order, or 40 radio stations (CFD-S350L), 20 for FM, 10 for MW and 10 for LW in any order. 1 Press RADIO BAND•AUTO PRESET to select the band. 2 Hold down RADIO BAND•AUTO PRESET for 2 seconds until “AUTO” flashes in the display. 3 Press DISP/ENT/MEMORY. The stations are stored in memory from the lower frequencies to the higher ones. If a station cannot be preset automatically You need to preset a station with a weak signal manually. 1 Press RADIO BAND•AUTO PRESET to select the band. 2 Tune in a station you want. 3 Hold down DISP/ENT/MEMORY for 2 seconds until the preset number flashes in the display. 4 Press PRESET + or – until the preset number you want for the station flashes in the display. 5 Press DISP/ENT/MEMORY. The new station replaces the old one.To turn on/off the power CFD-S350L: Press OPERATE. Falling asleep to music Remote Control FUNCTION BAND N OPERATE (POWER) VOL +*, – x .,> 1 Press CD (direct power-on). (On the remote, press OPERATE (or POWER) and then press FUNCTION repeatedly until “Cd” appears in the display.) 2 Load a CD in the CD compartment. 3 Press Z PUSH OPEN/CLOSE to close the CD compartmen...