Évaluations - 4, GPA: 4.5
(
)
)
|
Facilité d'utilisation
If a child accidentally swallows the battery, consult a doctor immediately. • Do not recharge, short, disassemble or heat the battery or dispose of it in a fire. Doing any of these things may cause the battery to give off heat, crack, or start a fire. • Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat, crack, or start a fire. • When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to give off heat, crack, or start a fire. • Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat, crack, or start a fire. • Dispose of battery in the proper manner, according to federal, state, and local regulations. • The batteries (battery pack or batteries installed ) shall not be exposed to excessive heat source such as sunshine, fire or the like. . Supplied Accessories After unpacking, check to be sure that you have all the following items. • Remote control • AC adaptor • Attachments (6 types) • Rubber pads (A type.2, B type.2) • CR2025 (.2) lithium coin batteries One is loaded on the remote control at the factory. . Prepare the Remote Control • When you use the remote control for the first time, pull out the insulation sheet. Replacing the Battery in the Remote Control • Insert the battery into the remote control by matching the polarity (+ and –) correctly. Insulation sheet Lithium coin battery (CR2025) . Preparation of the Unit 9V 1.5A . Loading batteries for the Clock Be sure to match the poles (+/-) correctly. FM wire antenna (Pass through the notch in the cover) 1 SOURCE button Switch the sound source. 2 FM MODE button Switch FM stereo/monaural. 3 MUTING button Turn off the sound. Return to original mode by pressing again. 4 PRESET +/- button Select a registered FM radio station (P01 to 20). 5 iPod 6 button Play/pause the iPod. 6 button Switch the backlight on/off. 7 4/. button Fast-forward/rewind the iPod song. Change frequencies to tune in to FM radio station. 8 VOLUME +/- button You can adjust the volume level from 00 to a maximum of 20. Troubleshooting If you are having a problem with your System, check this list for a possible solution before calling for service. In These Cases Check the following points Power does not come on. • AC adaptor is not inserted securely. Plug in securely. • The batteries are exhausted. No longer works. Press the “RESET” button (see “Resetting the unit”). Cannot set the iPod. • Is the selected attachment compatible to your iPod? Confirm the compatibility of iPod and attachments in “iPod Compatibility Chart”. • Is the attachment properly mounted on the unit? Make sure to mount the attachment properly. Cannot operate iPod. • Is the iPod firmly connected to the connector plug of the unit? • Is the iPod properly functioning? Test the iPod functions in stand alone condition. iPod cannot be charged. • Is the iPod firmly connected to the connector plug of the unit? • Is the AC adaptor connected? Make sure the AC adaptor plug is pushed in all the way. The iPod cannot be charged while the Unit is operated on batteries. • For iPod 3rd Generation, set the “CHARGING SWITCH” to “FIREWIRE” (see “Charging the iPod”). Hard to listen to broadcasts because of noise. The FM antenna is not properly extended and positioned. Unable to operate the System from the remote control. • The path between the remote control and the remote sensor on the System is blocked. • The batteries are exhausted. When the volume level is manually set higher than “08”, the unit automatically lowers the level to “08”. The unit’s battery runs low (The “---” (Low battery) appears on the display). Replace the batteries with new ones. . Resetting the unit If “Troubleshooting” does not eliminate malfunctioning (failure to operate or display properly, etc.), press the “RESET” button on the rear of the unit with something having a sharp point, while the unit is turned on. After pressing “RESET” button, unplug the AC adaptor and wait a while before plugging it again. • When using “RESET” button, make sure the lithium coin battery is loaded. • While resetting the unit, the clock is also reset. Adjust the clock after resetting the unit. 1 2 3 4 5 6 7 8 INSTRUCTIONS EN Open the battery compartment cover by pressing the small tab. . Loading batteries for the Unit (The battery power supply) Close the cover in the order shown by the numbers. R6 (SUM-3)/AA (15F) (not supplied) CAUTION: Danger of explosion if battery is incorrectly replaced. Insert three batteries to each compartment (six batteries total). Be sure to match the poles (+/-) correctly. Replace only with the same or equivalent type. While the AC adaptor is connected to the wall outlet, the unit works without batteries. (Front side) (Rear side) NOTES • Point the remote control at the remote control sensor on the front panel. • The remote control sensor is designed to receive signals from up to approximately 7 m distance when th...