Évaluations - 4, GPA: 3.5
(
)
)
|
Facilité d'utilisation
Also make all potentially dangerous parts of the appliance safe, above all for children who could mistake it for a toy. 17 Do not forget that the cooking zone stays hot for at least half an hour after it has been turned off. Take care not to inadvertently place pans or items on the hot zone. 18 Do not turn the cooking zones on if there is any aluminium foil or plastic material on the hob. 19 Do not get too close to the hot hob. 20 When using small electric appliances near the hob, keep the power supply cable away from the hot parts. 21 Make sure you turn the handles of pots and pans inwards to avoid knocking them over accidentally. 22 Never leave a cooking zone on without a pan on it, as the zone would heat up almost immediately, causing damage to the heating elements. 23 Remember to keep children away from the appliance when you use the grill or oven, since these parts become very hot. Keep children well away. 24 Make sure the knobs are in the ’V’/”°” position when the appliance is not in use. 25 If the cooker is placed on a pedestal, take the necessary precautions to prevent the same from sliding off the pedestal itself. Installation Instructions The following instructions should be read by a qualified technician to ensure that the appliance is installed, regulated and technically serviced correctly in compliance with current regulations. Important: The power supply to the appliance must be cut off before any adjustments or maintenance work is done on it. Positioning The cooker is manufactured with type X degree protection against overheating. Levelling Your Appliance (only on certain models) 4 support feet which are adjusted using screws are located in the lower part of the cooker. These level off the oven when necessary. It is essential that the cooker be standing level. Mounting the legs (only on certain models) Press-fit legs are supplied which fit under the base of your cooker. Fitting on a Power Supply Cable Opening the terminal board: • Using a screwdriver, prise on the side tabs of the terminal board cover; • Pull open the cover of the terminal board. To install the cable, proceed as follows: • unscrew the wire clamp screw and the contact screws Note: the jumpers are factory-set for a single-phase 230V connection (Fig. A). • to make the electrical connections illustrated in fig. C and fig. D, use the two jumpers housed in the box (fig. B - reference “P”) • fasten the supply cable in place with the clamp and close the cover of the terminal board. 230V 1N~ H07RN-F 3x4 CEI-UNEL 35364 ^ N L 1 n D©D ]©□ [ ©□ Fig. A P y—\ % <•) i □t N L1 ]
Plate - K6 E11/R (1.05 mb)