Évaluations - 3, GPA: 3.7 ( )

Fabricant : DCS Taille : 827.36 kb Nom Fichier : Langue d'enseignement:

3. Secure Front Section of backguard to Back Section with #8 self-tapping sheet metal screws supplied (fig. 02). Back Section Island Trim Slots to choose desired spacing between Range Island Trim and Backguard. 16”for30” 36”for36/48” Back Section Front Section # 8 Self-tapping sheet metal screws Fig.01 Fig.02 3 WALL MOUNT FULL BACKGUARD INSTALLATION RECOMMENDED INSTALLATION ORDER: 1) VENT HOOD 2)BACKGUARD SYSTEM 3) RANGE 1. Locate and level range per installation instructions. 2. After unpacking all backguard system parts, locate the Back Section 1/8” (see fig. 03) above and centered over the Island Trim attached to the range.* Secure Back Section to wall with the appropriate fasteners (not supplied) to anchors or wood stud (fig. 03). WARNING: The Back Section must be securely fastened to the wall. Failure to do so could cause damage or personal injury if the Backguard was to pull free from wall when racks are loaded. The maximum weight placed on each rack should be 10 lbs. *After 1/8” is located, slots in back section may be used to adjust spacing between range island trim and backguard for a flush fit. 3. Attach rod, end caps and center stanchion to Front Section of backguard with #10 machine screws supplied (fig. 04). 4. Bend wedge-shaped tabs down on top of the front section approximately 3/16”. When mounting the front section, insure that these tabs engage the mating holes in the top of the rear section (see fig. 05, page 4). 5. Secure Front Section of backguard to Back Section with #8 self-tapping sheet metal screws supplied (fig. 05, page 4). 6. Attach racks to rod (fig. 06, page 4). The maximum weight placed on each rack should be 10 lbs. #10 Machine Screws Back Section Island Trim Front Section End Cap End Cap Center Stanchion Rod Slots to choose desired spacing between Range Island Trim and Backguard. Bend down approx. 3/16” 16”for30” 36”for36/48” Fig.04 Fig.03 4 WALL MOUNT FULL BACKGUARD INSTALLATION #8 Self-tap- ping sheet metal screws Back Section Front Section Rack Holes* Tabs* Fig.05 Fig.06 *Insure tabs and holes engage to secure top of backguard. CARE AND MAINTENANCE This is made of stainless steel. Use the mildest cleaning procedure first. Hot soapy water, rinse and dry. If the panel has food soil remaining, try a general kitchen cleaner, such as Fantastik®, Simple Green® or Formula 409®. Apply cleaner with a damp sponge, rinse thoroughly and dry. Always scrub lightly in the direction of the grain. Do not use a steel wool pad, it will scratch the surface. To touch up noticeable scratches in the stainless steel, sand very lightly with dry 100 grit emery paper, rubbing in the direction of the grain. After cleaning use a stainless steel polish, such as Stainless Steel Magic®. If the rear top burners are used extensively on high it is possible for the vertical stainless steel panel to discolor from the burner heat. This discoloration can be removed by using Revere Ware Stainless Steel Cleaner. 5 NOTES DOSSERET POUR CUISINIERES Guide ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :