Évaluations - 4, GPA: 3.3
(
)
)
|
Facilité d'utilisation
1) 3. Place the column left assembly (30002074) onto the key. (Fig. 2) 4. Install the upper mountingbracket. Use the upper mounting bracket marked R (30002054) for the LHER20. Use the unmarkedupper mounting bracket (30002053) for LHEC30and LHEC20. (Fig. 3) 30001987 8/08 Rev. 4 5. Fasten the upper mounting bracket to the key with a 1/4-20 wing screw and 1/4 flat washer finger tight. (Fig. 3) 6. Fasten the upper mounting bracket to both column assemblies using (2) 1/4-20 wing screws and (2) 1/4 flat washers per side finger tight. The distance between the insides of the columns should measure: LHEC30 = 293/i6” (741mm) LHEC20 & LHER20 = 25%” (651mm) 7. Adjust the column/boot length (measure from the bottom side of the key to the bottom of the boot). LHEC30 = 221/4” (565mm) LHEC20 = 181/4” (464mm) LHER20 = 17%” (448mm) 8. Lift the surround up and parallel to the fireplace front. Press the Fan ON/OFF switch into the switch bracket. It will snap into place. (Refer to Homeowner’s manual for additional switch installation instructions) Move the surround towards the fireplace about an inch above the hearth. As you lower the surround onto the fireplace, the side clips and top bracket will engage mating clips. If height and width adjustments are required, lift the surround up and out. Make the adjustments. Regardless if adjustments were made or not, tighten all wing screws fasteners and return the surround to the fireplace. _MHSC_ 149 Cleveland Drive • Paris, Kentucky 40361 www.mhsc.com...
Ce manuel est également adapté pour les modèles :Plate - LHEC20 (264.88 kb)