Évaluations - , GPA: ( )

Instructions DCS, Modèle DD124

Fabricant : DCS
Taille : 1.61 mb
Nom Fichier : da728198-60e1-4e85-bfd8-55ee7d868da5.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Ensure moisture protection tape has been applied and the cabinet is sealed according to the DishDrawer® Installation Instructions. The DishDrawer® opens and closes freely. The DishDrawer® must be free to close completely with no resistance from cabinetry. For the integrated models, check the 5/16” air gap has been achieved in the correct place. The power supply is connected and switched on. The inlet water hose is connected and turned on. There should be no leaks. The drain hose(s) are connected and there are no leaks. There must be no kinks, or obstructions in the drain hose(s). The spray arm is in the center and can freely rotate. The rinse program has been run. The water level will be below the stainless steel filter plate at the end of the wash program. It is normal to find some water in the drain filter area. Set the water softener to the correct water hardness for your area (DD224-H, DD124-H models only). Important! The installer is responsible for the DishDrawer® installation. Incorrect installation is not covered by warranty. IMPORTANT SAFETY INFORMATION SAVE THESE INSTRUCTIONS WARNING! For your safety, follow basic precautions when using your DishDrawer®, including the following: Please read all instructions before operating the DishDrawer®. The information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life. Use the DishDrawer® only for its intended function as described in this Use & Care. Use only detergents or rinse agent recommended for use in a domestic Dishwasher and keep them out of reach of children. Check that the detergent dispenser is empty after the completion of each wash program. When loading items to be washed locate sharp items so that they are not likely to damage the lid seal and load sharp knives with the handles up to reduce the risk of cut type injuries. Do not touch the heater plate during or immediately after use. Do not operate your DishDrawer® unless all the enclosure panels are properly in place. Do not tamper with the controls. Do not abuse, sit on, stand in or on the drawer or dish rack of the DishDrawer®. The cup racks are designed to support cups, glasses and kitchen utensils. When the cup racks are in the DishDrawer® do not lean on or use the cup racks to support your body weight. To reduce the risk of injury, do not allow children to play in or on the DishDrawer®. Under certain conditions hydrogen gas may be produced in a hot water heater system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been used for such a period, before using the dishwasher, turn on all hot water taps and let the water flow from each for several minutes. This will release any accumulated hydrogen gas. As gas is flammable, do not smoke or use an open flame during this time. Remove the door to the washing compartment when removing an old dishwasher from service or discarding it. Dishwasher detergents are alkaline. They can be dangerous if swallowed. Avoid contact with skin and eyes, keep children and infirm person(s) away from the dishwasher when the drawer is opened. INSTALLATION This DishDrawer® must be installed and located in accordance with the Installation Instructions before it is used. If you did not receive Installation Instruction sheets with your DishDrawer®, you can order them by calling your Authorized Service Agent. Installation and service must be performed by a qualified technician. If the power supply cord is damaged, it must be replaced by a dealer or Authorized Service Center or a similar qualified trades person in order to avoid a hazard. Ensure the DishDrawer® is secured to adjacent cabinetry using the brackets provided. Failure to do so may result in an unstable product, which may cause damage or injury. Do not operate this appliance if it is damaged, malfunctioning, partially disassembled or has missing or broken parts, including a damaged power supply cord or plug. Do not store or use petrol, or other flammable vapors and liquids in the vicinity of the DishDrawer®. Connect to a properly rated, protected and sized power supply circuit to avoid electrical overload. Make sure that the power supply cord is located so that it will not be stepped on, tripped over or otherwise subject to damage or stress. Do not install or store the DishDrawer® where it will be exposed to temperatures below freezing or exposed to weather. Do not use an extension cord or a portable electrical outlet device (e.g. multi socket outlet box) to connect the DishDrawer® to the power supply. MAINTENANCE Do not repair or replace any part of the appliance or attempt any servicing unless specifically recommended in this Use & Care. We recommend that you call an Authorized Service Agent. Keep the floor around your appliance clean and dry to reduce the possibility of slipping. Keep the area around/underneath your appliance free from the accumulation of combustible mat...