|
Facilité d'utilisation
Low or no water. Chemicals won’t feed intodishwasher. Door not closed. Main power OFF. Dishwasher OFF. Main water supply off. Solenoid valve defective. Solenoid strainer clogged. Flow washer defective. Timer board defective. Chemical supply low. Supply tubing damaged. Supply tubing kinked. Pick-up tube cloggedTimer board defective. Close door completely. Check breaker on panel. Turn dishwasher ON. Open supply valve. Install repair kit or replace. Clean strainer. Replace flow washer. Test/replace timer board. Refill chemical container. Replace tubing. Straighten tubing. Clean/replace tube. Test/replace timer board. Low water pressurepumped from spray arms. Clogged scrap screen. Clogged spray arms. Clogged pump intake screen. Clean scrap screen. Clean spray arms. Clean sump and pump intake screen. Water has drained out of the wash tank while the dishwasher was idle. Goose-neck loop in drainhose has been removed. Drain hose clamp is notholding the drain hose in proper position. Building plumbing does notprovide correct air ventto prevent siphoning. Re-route drain hose. DO NOT STRETCH HOSEReplace/Adjust hose clampmaking sure goose-neckis maintained. Contact Service Agentand/or plumber. (HT models only) dishwasher stays inwash cycle. Rinse Sentry extends wash mode for a maximum time of 5-minutes to allow final rinse water booster temperature to reach 180°F/82°C. (501HT only) dishwasher is in Extended Wash Mode. Raise incoming water temperature. Adjust/replace final rinse booster thermostat. Turn Extended Wash Modeoff. Poor wash results.Water temperature low. Thermostat defective. (See chemicals won’t feed above.) (See low or no water above.) Detergent injector defective. Wares incorrectly loaded. in dishrack. Raise incoming watertemperature. Adjust/replace thermostat. (See chemicals won’t feedabove.) (See low or no water above.) Replace squeeze tube. Replace injector motor. Clean tubing and pick-up. Reposition wares or reduce amount of wares. Blank Page This Page Intentionally Left Blank 23 Service Replacement Parts Service Replacement Parts Illustration Pg. Wash Pump/Motor Assy - All Models........................................................... 24 Wash Tank, Drain, Scrap Screens - All Models........................................... 26 Built-in Electric Booster (201HT, 401HT, 501HT)........................................ 28 Base Electrical Components - All Models.................................................... 30 Fill Piping - All Models................................................................................. 32 Fill Valve Assy - All Models.......................................................................... 34 Fill Chute Assy - All Models......................................................................... 36 Sprayarm Assy - All Models......................................................................... 38 Main Terminal Block, Timer Board - All Models.............
Ce manuel est également adapté pour les modèles :Lave-vaisselle - 501-HTN (5.87 mb)
Lave-vaisselle - 201HT (5.87 mb)
Lave-vaisselle - 201HTN (5.87 mb)
Lave-vaisselle - 201LT (5.87 mb)