Évaluations - 0, GPA: 0 ( )

Fabricant : Bosch Taille : 3.12 mb Nom Fichier : Langue d'enseignement:

1. Check the fuse or circuit breaker box and replace the fuse or reset the breaker if necessary 2. Ensure door is properly latched and completely closed Dishwasher seems to run a long time 1. Incoming water is not warm enough 2. Cycle time can vary due to soil and water conditions 3. Rinse aid dispenser is empty 4. Dishwasher connected to cold water supply Note: Refer to “Wash Cycle Information” (page 11) section in this manual for typical cycle lengths 1. Before starting a cycle, run hot water faucet at the sink closest to the dishwasher 2. Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected 3. Add rinse aid 4. Verify dishwasher is connected to hot water supply plumbing Dishes are not getting clean enough 1. Spray arm movement obstructed 2. Spray arm nozzles clogged 1. Ensure that spray arm movement is not blocked by hand rotating spray arms before starting cycle 3. Improper use of detergents 4. Filters could be clogged 5. Dishes are nested or loaded too close together 2. Remove the spray arms and clean according to the “Care and Maintenance” (pages 12-13) section of the manual 3. Increase or decrease detergent depending on the water hardness 6. Selected wash cycle is not suitable for food soil conditions (refer to Table 1) 4. Clean the filters according to the “Care and Maintenance” (pages 12-13) section of the manual 5. Rearrange load such that water spray can reach all items in the dishwasher - see “Loading the Dishwasher” (page 6) section of the manual 6. Refer to “Wash Cycle Information” (page 11) section of the manual Dishes are not get1. Rinse aid dispenser is empty 1. Add rinse aid - the use of rinse aid improves drying ting dry enough 2. Improper loading of dishes 2. Rearrange load to ensure items are not nesting (see “Loading the 3. “Added heat for drying” is not activated Dishwasher” (page 6) section of the manual) Note: Plastic or Teflon do not typically dry as well as 3. See the “Operating the Dishwasher” (page 11) section of this man- other items due to their inherent properties ual to learn how to activate the added heat for drying Odor 1. Food debris is present at the bottom of the dishwasher 2. Food particles are present near the door seal 3. Residual water is present at the bottom of the dish1. Remove the filters and clean according to the “Care and Maintenance” (pages 12-13) section of the manual 2. Refer to “Care and Maintenance” (pages 12-13) section of the manual washer 4. Drain hose is obstructed 3. Ensure the unit has completely drained from the last cycle 4. Remove any obstructions from the drain hose by calling qualified personnel Note: If odor still persists, run the Normal/Regular cycle until it flushes and interrupt the cycle and place an 8oz. cup of distilled white vinegar solution on the top rack and then finish the cycle. Problem Cause Action Dishwasher not fill-1. Restriction in the water supply system 1. Ensure that the water supply valve (typically located under kitchen ing with water 2. Previous wash cycle was not completed sink) is open and check that the water supply line has no kinks or clogs 3. Delay start is active 2. Refer to the “Operating the Dishwasher” (page 11) section of the 4. Household water supply is off manual 3. Cancel the delay start or wait until delay start time completes 4. Turn household water supply on Water leaks 1. Suds 2. Door seal could be pulled away from track 3. Condensation vent is blocked 4. Improper installation 1. Wrong type of detergent results in suds and leaks - use only dishwasher detergents. If suds still persist, add one tablespoon of vegetable oil at the bottom of the dishwasher and run the desired cycle. 2. Ensure the door seal is in the track 3. Ensure that condensation vent is not blocked 4. Have proper installation verified by qualified personnel (water supply, drain system, leveling, plumbing) Tub stains 1. Stains on the dishwasher interior are due to water hardness 2. Silverware in contact with tub 1. Concentrated lemon juice can reduce the build up of hard water stains. Run a Regular cycle until it flushes and interrupt the cycle and then place an 8oz. cup of the concentrated lemon solution on the top rack and finish the cycle. this can be done periodically to avoid build up 2. Ensure that silverware does not make contact with the tub while running a cycle Streaks on glassware or residue on the dishes 1. Incorrect rinse aid setting 1. Depending on the hardness of water, adjust the rinse aid dispenser. Refer to “Adding Detergent and Rinse Aid” (page 9) section in the manual Fascia panel discolored or marked 1. Abrasive cleaner used 1. Use mild detergents with soft damp cloth Noise during wash cycle 1. Dishes may not be arranged properl y 1. Water circulation sound is normal, but if you suspect items are banging into each other or into the spray arms, refer to the “Loading the Dishwasher” (page 6) section of the manual for optimal arrangement Detergent dispenser co...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :