Évaluations - 2, GPA: 4.5
(
)
)
|
Facilité d'utilisation
E. Atlanta, GA 30345-2979 Emergency Telephone: (800) 526-4371 MATERIAL SAFETY DATA SHEET Section 1: Chemical Product and Company Information Identity: Product ID: Synonyms & Common Names: Uses: 5485 Toner 480-0034 Toner for Lanier 5485 Lanier 5485 MSDS No. Issued: Supersedes: Date: Prepared by: Approved by: European Contact: CP- 339 04/20/2000 None 04/20/2000 EH&S Department 770-496-9500 Larry Choskey, Manager, CEH&S Walter Fricke, Manager, Safety & Environment, Lanier Worldwide, Inc. Chemical Im Taubental D-41468 Neuss, Formula: Mixture Germany +49-2131-387-177 Section 2: Composition / Information on Ingredients PERCENT CAS No. EXPOSURE LIMITS SOURCE Polyester resin 60 – 80 Confidential 8mg/m3 ACGIH TWA Styrene acrylic polymer 10 – 30 25767-47-9 Not listed N/a OSHA PEL ACGIH TWA Carbon black 7 – 15 1333-86-4 3.5mg/m3 3.5mg/m3 Wax < 5 8015-86-9 Not listed N/a Dye < 1 31714-55-3 Not listed N/a *PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust) *TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust) Section 3: Hazards Identification HMIS Rating: FLAMMABILITY = 1 HEALTH = 1 REACTIVITY = 0 SPECIAL = none Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any nontoxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort. Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function properly in Xerographic equipment. Carbon Black is listed on the IARC Monograph and the Massachusetts Substance List. The IARC has evaluated the evidence for the carcinogenicity of Carbon Black as inadequate to determine a carcinogenic risk for humans. This product contains no known hazardous materials as defined by the OSHA Hazard Communication Standard 29 CFR 1910.1200. Section 4: First Aid Measures Remove to fresh air if effects occur. Get medical In case of contact, immediately flush eyes with Inhalation: attention if needed. Eye Contact: water for 15 minutes. Get medical attention if needed. Skin Contact: Wash with soap and water. Ingestion: Dilute stomach contents with several glasses of water. Get medical attention. Section 5: Fire Fighting Measures Suitable extinguishing media: CO2, dry chemical, foam or water. Extinguishing media which may not be used for safety reasons: none This material will burn in case of fire. The decomposition products are CO, CO2, and Nox. Avoid inhalation of smoke. Special protective equipment for fire fighters: none UEL: n/a LEL: n/a MATERIAL SAFETY DATA SHEET Page 2 of CP-339 Section 6: Accidental Release Measures Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold water. Miscellaneous: Keep product out of sewers and watercourses. Personal protection: Avoid inhalation of dust. Section 7: Handling and Storage Special Handling: Cleanse skin after contact before breaks or meals, and end of workday. Special Storage: Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Section 8: Exposure Control and Personal Protection Information: Respiratory Protection: none required under normal use. Hand Protection: none required under normal use. Eye Protection: none required under normal use. Skin Protection: none required under normal use. Section 9: Physical and Chemical Properties CHARACTERISTICS: Appearance: Black Melting point: n/a Form: Powder Vapor pressure: n/a Odor: Slight plastic odor Vapor density: n/a Solubility in Water: Insoluble Evaporation rate: n/a Specific gravity: N/a Boiling point: n/a Bulk Density: 1.2 g/cm3 Section 10: Stability and Reactivity Conditions to avoid: none Materials to avoid: none Stability: Stable Hazardous decomposition products: CO and CO2 and other decomposition products when burned. Section 11: Toxicological Information: Ames test negative Acute oral toxicity: >5000mg/kg (rat) Section 12: Environmental / Ecological Information Acute toxicity to fish: >500 mg/kg/96hr. Section 13: Disposal Consideration Used Toner should be disposed of under conditions t...