Fabricant : Magikitch'n
Taille : 601.88 kb
Nom Fichier : d9b4ce67-cabf-4a5a-bd2d-0f3a6eceed57.pdf
|
Facilité d'utilisation
CONCORD, NH 03301 TEL: 800-258-3708 • 603-225-6684 • FAX: 603-225-8497 L25-050 Rev. 0 MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE FOR YOUR SAFETY DO NOT store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WARNING Improper installation, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. TO THE PURCHASER Post in a prominent location the instructions to be followed in the event that an operator smells gas. Obtain this information from your local gas supplier. WARNING There is an open flame inside this appliance. The unit may get hot enough to set nearby materials on fire. Keep the area around the appliance free from combustibles. WARNING DO NOT supply the appliance with a gas that is not indicated on the data plate. If you need to convert the appliance to another type of fuel, contact your dealer. WARNING DO NOT use an open flame to check for gas leaks! WARNING If gas flow to appliance is interrupted, or pilots extinguish, wait 5 minutes before attempting to relight the pilot to allow any residual gas in appliance to dissipate. WARNING Ensure that the appliance can get enough air to keep the flame burning correctly. If the flame is starved for air, it can give off a dangerous carbon monoxide gas. `Carbon monoxide is a clear odorless gas that can cause suffocation. WARNING An appliance equipped with casters and a flexible gas line must be connected to the gas supply with a quick disconnect device. This quick disconnect must comply with ANSI Z24.41. To limit the movement of the appliance without depending on the connector or quick disconnect, a restraining cable must also be installed. WARNING Models with electric controls are equipped with an oil proof electrical supply cord, with a three- prong safety plug. This is to protect operators from electrical shock hazard in the event of an equipment malfunction. DO NOT cut or remove the grounding (third) prong from this plug. WARNING This appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.2, as applicable. WARNING The power supply must be disconnected before servicing or cleaning this appliance. WARNING Do not attempt to move this appliance when the unit is at operating temperature. Serious personal injury could result if skin comes in contact with the hot surfaces. i MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION Table of Contents 1. INSTALLATION SECTION:................................................................................................................................................... 1 1.1. CHECKING YOUR NEW GRIDDLE: ......................................................................................................................... 1 1.2. INSTALLATION CLEARANCES:............................................................................................................................... 1 1.3. GAS CONNECTION:....................................................................................................................................................1 1.3.1. Fuel Types:.............................................................................................................................................................2 1.3.2. Quick Disconnect Connection:............................................................................................................................... 2 1.3.3. Fuel Supply Line and Leak Pressure Testing: ........................................................................................................ 2 1.4. VENTILATIONAND FIRE SAFETYSYSTEMS:......................................................................................................2 1.5. INSTALLATION, SET UP:........................................................................................................................................... 3 1.5.1. For Counter Use With Legs:................................................................................................................................... 3 1.5.2. For Counter Use Without Legs: ............................................................................................................................. 3 1.5.3. For Use on Optional Equipment Stand:.................................................................................................................. 4 1.6. FINAL GAS CONNECTION: ....................................................................................................................................... 5 1.6.1. Regulator Assembly: .................................................................................................