Évaluations - 4, GPA: 4.3 ( )

Fabricant : GE Taille : 603.54 kb Nom Fichier : 02643e4c-7268-41d8-abc5-78096d72b82f.pdf Langue d'enseignement:

CHECK FOR LEAKS4 Line up the disposer under the sink flange. Guide the hopper projections into the mount ring slots. Turn the mount ring about 1/4. to the right so that the disposer is temporarily supported. 1 Turn the mount ring and the disposer until the disposer discharge elbow lines up with the outlet pipe (see page 8). LINE UP WITH OUTLET PIPE2 Mount Ring Slot Hopper Projection Discharge Elbow Outlet Pipe ATTACH TO SINK FLANGE Installation Instructions DIMENSIONS GFC320F GFC325F 63/16” 5 3/16” 1211/16” 41/2” 11/2” 53/8” GFC520F GFC525F GFC530F GFC535F GFC720F GFC1020F 11/2” 11/2” 11/2” 59/16” 7 1/4” 8 1/2” 161/16” 71/4” 8 1/2” 5 9/16” 141/2” 615/16” 53/8” 73/4” 137/16” 4 1/2” 4 1/2” 4 1/2” GFB760F Batch Feed Operation 11/2” 93/8” 8 1/2” 5 9/16” 165/8” 41/2” 11/2” 59/16” 93/8” 8 1/2” 183/16” 4 1/2” GFB1060F Batch Feed Operation 63/16” 5 3/16” 1211/16” 41/2” 11/2” 53/8” SOME TYPICAL INSTALLATIONS SINGLE BOWL DOUBLE BOWL CENTER OUTLET** DOUBLE BOWL END OUTLET** *Approx. *Approx. *Approx. Direct replacement for most makes & models. *9. for model GFC320F, GFC520F, GFC325F, & GFC525F. *10. for models GFC530F, GFC535F, GFC720F & GFC1020F. *12. for models GFB760F & GFB1060F. **Flexible drain pipe may be necessary for this application. NOTE: It is essential for the proper operation of the disposer that this dimension be 9. –12. , depending upon the models listed above, to avoid standing water in disposer motor housing. Operating instructions. This disposer uses anti-jam swivel impellers that make a clicking sound as they swing into place. This indicates normal operation. Continuous Feed Models Consumer SupportTroubleshooting TipsInstallation InstructionsSafety Instructions Operating Instructions A. Remove the sink stopper and turn on a medium flow of cold water. B. Turn the switch to ON. C. Scrape in food waste. To speed up food waste disposal, cut or break up large bones, rinds and cobs. Large bones and fibrous husks require considerable grinding time and are more easily thrown away with other trash. Do not be alarmed that the disposer slows down while grinding. The disposer is actually increasing torque (grinding power) and is operating under normal conditions. Batch Feed Models D. Before turning the disposer off, let the water and the disposer run for approximately 25 seconds after shredding stops. This assures that all waste is thoroughly flushed through the trap and drain. E. Do not use hot water while running the disposer. Cold water will keep food waste and fats solid so they can be flushed down the drain. Oval Handle Small A. Remove the sink stopper and turn on a medium flow of cold water. B. Scrape in food waste. C. Insert the stopper to start the disposer. One of the two small slots in the stopper base must line up with the switch plunger inside the neck of the disposer. NOTE: The oval shaped handle aligns with the 2 small slots in the stopper. Push down firmly to start. D. Run the disposer for 25 seconds after shredding stops. This assures that all waste is thoroughly flushed through the trap and drain. Lift the stopper to shut the disposer off. E. To fill the sink, insert the stopper so that the largest slot lines up with the switch plunger. The stopper can now be pushed down to seal the sink without starting the disposer. When the medium-sized slot in the stopper base is lined up with the switch plunger, water can drain, but tableware, etc., cannot be accidentally dropped into the disposer. Large Small Medium 9 Consumer Support Troubleshooting Tips Operating Instructions Safety InstructionsOperating Instructions Operating instructions. Helpful Hints A. Be sure the disposer is empty before using the dishwasher so it can drain properly. B. You may want to leave the stopper in the drain when not in use to prevent utensils and foreign objects from falling into the disposer. C. The disposer is ruggedly built to give you years and years of trouble-free service. It will handle all normal food wastes–BUT it will not grind and dispose such items as tin cans, bottles and bottle caps, glass, china, leather, cloth, crockery, rubber, string, feathers, or clam or oyster shells. These are waste materials and belong in the trash can or trash compactor. Care and maintenance. D. TO SPEED UP FOOD WASTE DISPOSAL... Cut or break up large bones, melon rinds, grapefruit skins and corn cobs. Items such as large bones, fibrous husks like lima bean pods and corn husks require considerable cutting time. For this reason, you may prefer to place them in the trash can or trash compactor. THE MOTOR IS PERMANENTLY LUBRICATED FOR LIFE. DO NOT ATTEMPT TO LUBRICATE YOURDISPOSER. The disposer is self cleaning and scours itself with each use. ¦ nnNEVER put lye or chemical cleaners into the disposer, as they cause serious corrosion of metal parts. ¦ nnYour disposer, except for the Batch Feed model, is equipped with a removable splash guard for ease of cleaning or replacement. Remove the splash guard by pulling it o...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :