Évaluations - , GPA: ( )

Instructions Axor, Modèle 6802 Series

Fabricant : Axor
Taille : 131.56 kb
Nom Fichier :

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Check spout mounting and hose connections for leaks. Operate LIFT ROD and check DRAIN for leaks. Turn handles into OFF position and replace AERATOR. Apply a bead of PUTTY around the underside of DRAIN PLUG flange and insert DRAIN PLUG into SINK drain hole. Hold DRAIN PLUG firmly to prevent turning, and assemble the GASKET, WASHER, and LOCKNUT from underneath the SINK. Insert GASKET into COUPLING and attach COUPLING to DRAIN PLUG. Align COUPLING so that the ACTUATOR ROD faces rear of SINK and tighten LOCKNUT to secure position. Unscrew ACTUATOR NUT and withdraw the ACTUATOR ROD. Drop STOPPER into DRAIN PLUG with the OFFSET SQUARE SLOT in line with ACTUATOR ROD opening. Reassemble ACTUATOR ROD. Make sure ROD is inside offset square slot of the stopper. Tighten ACTUATOR NUT. Insert threaded end of TAILPIECE into lower end of COUPLING. Connect other end of TAIL PIECE to the TRAP. Slide EXTENSION onto ACTUATOR ROD and secure with CLIP. Slide EXTENSION onto LIFT ROD and tighten THUMBSCREW. Adjust LIFT ROD stroke for proper opening and closing of the stopper. To change direction of handle rotation, proceed as follows: Turn valve to OFF position. Remove INSERT and HANDLE SCREW. Slip HANDLE with ADAPTER off. Remove SPRING CLIP. Lift STOP WASHER, turn 90° and replace. Replace SPRING CLIP. Replace ADAPTER, HANDLE, SCREW, and INSERT. AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean. If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90°. Plastic SCREEN in CARTRIDGE may accumulate dirt causing reduced water flow. To clean, first turn off hot and cold water supplies, then: Remove INSERT and HANDLE SCREW. Slip HANDLE with ADAPTER off. Unscrew CARTRIDGE with wrench. Thoroughly rinse plastic SCREEN at base of CARTRIDGE. Replace CARTRIDGE until flange is tight against valve body. Turn valves OFF. Replace ADAPTER, HANDLE, SCREW, and INSERT. TEE SCREW O-RING O-RING Apply a bead of PUTTY around underside of DRAIN PLUG flange. Insert DRAIN PLUG into SINK drain hole. SHANK Remove COUPLING NUT, FRICTION RING, and RUBBER FERRULE from each valve and slide onto tubing. Push TUBING ends into VALVE side outlets. Insert VALVES into mounting holes from underside of SINK. Press TEE onto SHANK of SPOUT making certain that the SHANK O-RING is properly seated on SHANK. Slide RUBBER FERRULE, FRICTION RING, and COUPLING NUT to outlet of VALVE and tighten COUPLING NUT firmly. Repeat on other VALVE. Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of right VALVE using appropriate connector. Hold DRAIN PLUG to prevent turning and assemble GASKET, WASHER, and LOCKNUT, from underneath sink. Insert threaded end of TAILPIECE into lower end of DRAIN PLUG. Connect other end to trap. DRAIN ASSEMBLY (Models 6802 and 6832 only) (Models 6801 and 6831 only) PUTTY FLANGE DRAIN PLUG RUBBER GASKET WASHER LOCKNUT SINK 3VALVE INSTALLATION (continued) M34375C HOTLINE FO...