Évaluations - 4, GPA: 4 ( )

Fabricant : Image Taille : 537.12 kb Nom Fichier : Langue d'enseignement:

Always keep the buckles locked when the spa is not in use. Keep the keys in a safe place, out of the reach of children. Latch Key Buckle 10 Spa Shell Diagram Spa Shell Diagram A O LB D I E I H F M M M J J L L L L K K K K K K KG C N L L A. The filters can be removed for cleaning or replacement (see CHECKING AND CLEANING THE FILTERS on page 13). B. The underwater light can be used for night operation (see USING THE CONTROLS on page 12). The spa includes both red and blue covers for the light. C. The temperature probe monitors water temperature. D. The volcano jet provides a soothing foot massage. E. The whirlpool jet diverts the water flow three different ways. By turning the outer ring, you can divert the water flow between the volcano jet (D), the other jets on the spa, and the whirlpool jet (E), which creates a whirlpool action. Note: The outer ring may be hard to turn while the pump is turned on high. F. The four suction fittings provide water to the pumps. The suction covers should always be in place over the fittings. Never operate the spa without the suction covers in place. G. An optional ozone generator can be purchased and installed to utilize the ozone jet. Ozone helps sanitize the spa with minimal chemical treatment. H. The console controls the spa jets, turns the underwater light on and off, and adjusts the water temperature setting (see USING THE CONTROLS on page 12). I. The four air controls regulate the air flow to the whirlpool, hydrotherapy, and volcano jets. J. The two neck jets can be adjusted to spray soothing water on your neck. To activate the neck jets, turn the on/off valve (P) counterclockwise. To turn the neck jets off, turn the on/off valve clockwise. K. The twenty rotary jets provide a spinning massage. L. The dual rotary jets provide a pulsating massage action. Rotate the outer ring counterclockwise to turn the jets on. Rotate the outer ring clockwise to turn the jets off. M. The three variable-flow jets are fully adjustable. Turn the outer rings to regulate the flow. N. The power massage jet provides a soothing massage to your lower back. Turn the outer ring to regulate the flow. O. The skimmer cleans the surface of the water. 11 Using the Controls Air Control 4 Air Controls 1, 2, and 3 Light Button Pump Button 1 Pump Button 2 Display Display Invert Button Temperature Buttons 1 2 3 4 1 1 2 3 4 4 1 3 Air Control 1: Determines the amount of air flowing through the hydrotherapy jets labeled 1 (above). If the control is turned counterclockwise, the amount of air will increase; if the control is turned clockwise, the amount of air will decrease. Air controls 2–4 function in the same manner. Air Controls 2, 3, and 4: Determine the amount of air flowing through the hydrotherapy jets labeled 2, 3, and 4 (above). Display Invert Button: Turns the display 180°, allowing it to be read from inside or outside of the spa. Pump Button 1: Turns the spa jet labeled 3 and 4 (at the left) on and off. If the button is pressed once, the jet will run, providing gentle hydrotherapy. If the button is pressed again, the jet will shut off. Pump Button 2: Turns the spa jets labeled 1 and 2 (at the left) on and off. If the button is pressed once, the jets will run, providing soothing hydrotherapy. If the button is pressed again, the jets will shut off. The spa also features an automatic mode that heats and filters the water when the spa is left unattended. When the power to the spa is first turned on, or if the water temperature is below the set temperature, the water will be heated as required. Note: To keep the filter and heat cycles from running, the power to the spa must be turned off. Light Button: Turns the underwater light on and off. Temperature Buttons: Control the temperature setting of the water. The temperature setting can be from 80°F to 104°F. The water heats at about 6°F per hour with the cover on. Use a medical or other accurate thermometer to check the temperature of the water. Note: The word “COOL” will appear in the console display if the temperature of the water is more than 20°F cooler than the set temperature. When this happens, the heater will automatically activate to warm the water. The word “ICE” will appear in the display if the temperature drops below 40°F. If this happens, the pump will automatically circulate the water and warm the plumbing to keep the water from freezing. Neck Jet Valve: Controls water flow to the two neck jets (see J on page 11). 12 Maintenance The hydrotherapy spa is designed to provide years of enjoyment. Please follow the guidelines below to properly maintain your spa. MAINTENANCE SCHEDULE Daily • Check the water level and refill the spa to the level shown in step 5 on page 9. • Check the pH balance and sanitizer level. Adjust if necessary (see WATER CHEMISTRY on this page). MAINTAINING THE SPA COVER The spa cover should be cleaned monthly. To clean the spa cover, use water and a non-abrasive cleaner on the entire cover. Rinse the cover with a garden hose ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :