Évaluations - , GPA:
(
)
)
Fabricant : Cal Flame
Taille : 1.61 mb
Nom Fichier : 2009_06_02_Villa_Owner_Manual.pdf
Langue d'enseignement: 
Le document est chargé, s'il vous plaît patienter
 |
Le document est chargé, s'il vous plaît patienter
Facilité d'utilisation
If you are installing a spa or villa on an elevated • wood deck or other structure, we strongly recommend that you consult a structural engineer or contractor to ensure the structure will support the weight of 150 Lbs./ sq. ft. It is strongly recommended that a qualified, • licensed contractor prepare the foundation for your villa. Size Specifications Length Width 12’ 12’ 12’ 16’ 14’ 14’ 14’ 18’ 16’ 16’ NOTE: We recommend that the foundation extend beyond the dimension of the villa. For example, if the villa you purchased is 12’x12’, you will want your foundation to be 12’x12’. The reason for this is because it will be easier to maintain the area around the villa (mowing the lawn, edging, etc.) without damaging or scarring the villa. Also, in doing this, you will eliminate any potential problems, foundation-wise, in the future. NOTE: This owner’s manual applies to the various sizes that are included in the villa line. While the sizes will vary from villa to villa, the assembly instructions will be the same, unless otherwise noted. 2 Assembly 2009 Villa LTR20091034, Rev. A Villa Assembly Column Placement Reference your column placement chart for the particular villa you purchased. The center point measurements will be described for your particular sized villa. Please locate these dimensions and mark them on your floor or professionally laid slab. If your municipality requires a footing please see our recommendations for proper column installation. Anchoring the Main Support Post When scoring the concrete, make sure that the mark is dark enough to see, as you will be drilling a hole in the concrete. This hole will be where the anchoring bolt is located. Also, it is the owner’s responsibility to obtain a 1/2” masonry bit. This bit will be used to drill the anchoring holes in the foundation. A masonry bit may be bought at any local hardware store. Refer to Figure 1 for steps 1 through 3. Pre-drill the anchoring hole using a 1/2”masonry 1. drill bit (see NOTE above). Drill the hole to a depth of no less than 3”. Using a hammer, insert the anchoring bolt by gently tapping the bolt into place. Continue to tap into place until the anchoring bolt is seated securely in the hole. After drilling the hole and inserting the anchoring 2. bolt, slide the main support post assembly on to the anchoring bolt and tighten down using the provided hardware. Repeat these steps for all four corners of the 3. villa. Figure 1. Anchoring the main support post The final placement of the main support posts is shown in Figure 2. The main support posts should be mounted no less than 1” from the side of the spa. If the villa is touching the spa, and any damage is incurred due to contact, the warranty on the spa siding is void. The total distance between each main support post will be determined by the size of the spa and villa that was purchased. The list below will tell you what each distance should be for each model: If the spa is: The distance between each villa main support post is: 7’ x 7’ ± 7’ - 2” x 7’ - 2” 7.5’ x 7.5’ ± 7’ - 8” x 7’ - 8” 8’ x 8’ ± 8’ - 2” x 8’ - 2” Figure 2. Placement of the support posts Method A Method B Method C Roof Assembly Appendix Cleaning Your villa was designed with low cleaning and maintenance in mind. We recommend that the surround package be cleaned at least twice a month (or more, if needed). When cleaning your villa, do not use cleaning solvents -- using a sponge and water will be fine. For ground-in dirt and grime, refer to the following section. Maintenance Maintaining your villa is an easy task. We recommend that every six months you inspect your surround package. Take note of any deformities in the wood (i.e. cracking, peeling, dirt, grime, etc.). Wipe the stained area clean and reapply until the sanded area matches the rest of the villa. Warranty Information See your Cal Enclosures villa dealer for a copy of the applicable warranty, details and any questions you may have regarding the warranty coverage on your villa. Warranty Limitations The Limited Warranty is void if the villa has been subject to negligence, alteration, misuse, abuse, repairs by non-LMS authorized representatives, acts of God and any other cases beyond the control of LMS. Examples of common acts invalidating this warranty include but are not limited to: Use of the villa in a non-residential application• Scratches caused by normal use• Damage caused by extreme weather conditions (heat, cold, etc.)• Damage caused by dirt, sand, and/or water damage• Damage caused by direct sunlight• Damage caused as a result of failure to follow the assembly instructions as defined in this owner’s manual• This Limited Warranty applies only to villas normally used for personal, family, or household purposes. This Limited Warranty is obsolete 90 days after the original purchase date. Warranty Exclusions LMS warranties the villa from defects in material and workmanship for a period of 90 days from the original date of purchase. DON’T ...