SAVE THIS MANUAL FOR FUTURE REFERENCE. Step 1 Attach the ground stake to a pointed connector. Push approximately 3" of the ground stake into the ground. If the ground is too hard, soak area with water to soften. Step 2 Align the connector to the grooves on bottom of light head. Turn counter-clockwise to set in place. Step 3 Insert light head into ground stake. The photocell light sensor should point away from other nighttime light sources. Step 4 Charge in direct sunlight for 10-12 FULL, SUNNY D

ASSEMBLY INSTRUCTIONS Inspect contents of the Victorian Light Fixture 3-Piece Hanging Hook Ground Stake PARTS LIST: 1 2 3 1 2 3 Select a location with full, direct sunlight. Shady locations will not allow the battery to charge fully and will reduce the hours of nighttime light. NOTE: The rechargeable Ni-Cd battery must be allowed to fully charge to operate properly. Partially charging the battery on a consistent basis will drastically reduce the life of the battery. The selected location should

At night, the light turns on automatically using the electricity stored during that day. The number of hours the light will stay on is dependent on your geographical location, weather conditions and seasonal lighting availability. Solar lights do not receive as much direct sunlight in winter months. Therefore, the number of hours the light will stay on will be reduced during winter. BEFORE FIRST USE – Pull out to remove the clear plastic strip with orange sticker in the light fixture to charge b

• Other light sources: If your solar lights are located too close to a street light, porch light or another solar light, it may not turn on automatically at night. The built-in photocell light sensor is reacting to the other light source. Eliminate the other light source or relocate your solar lights. • Dirty solar panel: A dirty solar panel will not allow the battery to fully charge. This will shorten the life of the battery and cause the light to malfunction. Clean regularly with a dampened cl

Therefore, the number of hours the light will stay on will be reduced during winter. 1 BEFORE FIRST USE – Pull out to remove the clear plastic strip with orange sticker in the light fixture to charge batteries. Your new solar light’s rechargeable Ni-Cd battery is fully charged and ready for use. Install the solar light in direct sunlight. For optimum performance, it is best to charge the solar light for a FULL, SUNNY DAY. The light will turn on automatically at night. The Ni-Cd rechargeable batt

SE PUEDE PRODUCIR UNA EXPLOSION PELIGROSA SI SE HACE CASO OMISO A ESTAS ADVERTENCIAS E INSTRUCCIONES. LEA Y SIGA TODAS LAS ADVERTENCIAS E INSTRUCCIONES EN ESTE MANUAL PARA EVITAR LESIONES PERSONALES, INCLUSO LA MUERTE, O LOS DANOS MATERIALES. INSTRUCCIONES DE ARMADO Y OPERACION SAVE THIS MANUAL FOR FUTURE REFERENCE GUARDE ESTE MANUAL PARA REFERENCIA FUTURA NOTICE TO INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE FIREPIT OWNER FOR FUTURE REFERENCE. AVISO PARA EL INSTALADOR: ENTREGUE ESTAS INSTRUCCI

• A damaged battery can leak acid. Avoid contact with eyes and skin. If contact occurs, flush immediately with large amounts of water. DO NOT ingest. If contact with eyes or ingestion occurs, consult physician immediately. USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR SPOTLIGHT. FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS MANUAL COULD RESULT IN BODILY INJURY OR PROPERTY DAMAGE. SAVE THIS MANUAL FOR FUTURE REFERENCE. INSTR-800-2200-0_Dual Xenon.qxd 6/24/03 3:23 PM Page 3 OP

Step 3 Insert light head into ground stake. The photocell light sensor should point away from other nighttime light sources. Step 4 Charge in direct sunlight for 10-12 FULL, SUNNY DAYS. The light will turn on automatically at night. Allow at least 10-12 cycles (i.e., 10-12 days and nights of charging and discharging) for the battery to charge to its full capacity. Deck/Wall/FenceMounting: Select a location with full, direct sunlight. Shady locations will not allow the battery to charge fully and

The light will stay on as long as the motion detector senses motion in the zone. The light will turn off in approximately 90 seconds after the person leaves the detection zone or stops moving. During the day, the solar panel converts sunlight into electricity and recharges the battery in the main housing. At night, the light turns on automatically when it detects motion using the electricity stored during that day. The number of activations per night are dependent on your geographical location,

A dirty solar panel will not allow the battery to fully charge. This will shorten the life of the battery and cause the light to malfunction. Clean regularly with a dampened cloth or paper towel. Solar lights can be left outside year round, even in cold weather. However, if you wish to store your light indoors for more than two or three days, follow these steps to prevent damage to rechargeable batteries: • Store at room temperature in a dry location. • Store solar light where it can receive som