Pull hair back with one hand. Bring facepiece up to face with other hand. While holding the facepiece in place, pull the straps over your head. Tighten the two bottom straps. Tighten the two middle straps, then the two top straps. Issue Date 01/01/04 Check the seal of your elastomeric full face, 6 strap respirator each time you don the respirator. 1. Positive Pressure User Seal Check Place the palm of your hand over the exhalation valve cover and exhale gently. The facepiece should bulge

• Ensure the exhalation vent holes are clear. Check Valve Function WARNING DO NOT use the mask if the valve flap is damaged or missing. NOTE: If the valve flap is damaged, distorted, or torn, it should be replaced with a new part. NOTE: For this procedure, refer to SECTION C in supplemental sheet provided. 1. Connect a standard 22mm bore, 6-foot tube from your flow generator to the hose swivel by pressing the tube end over the swivel. 2. Turn On the flow generator. Part No 1130237 5 Invacare®Tw

The plug and outlet should look like those in the following illustration. (See Figure A.) PAGE 7 DOUBLE INSULATED TOOLS: TOOLS WITH TWO PRONG PLUGS 4. Tools marked “Double Insulated” do not require grounding. They have a special double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc., the Canadian Standard Association, and the National Electrical Code. (See Figure B.) 5. Double insulated tools may be used in either

Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. PRODUCT SPECIFICATIONS Model HGS220/440LB HGS550/1100LB HGS750/1500LB HGS1000/2000LB Standard version With pulley Hook Standard version With pulley Hook Standard version With pulley Hook Standard version With pulley Hook Load capacity 220lb 440lb 550lb 1100lb 750lb 1500lb 1000lb 2000lb Lifting height 36ft 18ft 36ft 18ft 36ft 18ft 36ft 18ft Lifting speed 33ft/min 16.5ft/min 33ft/min 16.5ft

If you are unable to hoist a load and the load is under the maximum lift capacity, stop the Hoist and allow the motor to cool down before trying again. 18. Make sure the cable is correctly wound around the wheel. See FIGURE 1 below. 19. Do not support a load over or around people or animals. 20. Do not leave load suspended in the air unattended. 21. Do not allow a load to bear against the hook latch. Allowing a load to bear against the hook latch can result in loss of load. 22. Do not allow load

Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item#142264 Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., INC. Product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This machine is de

Service or maintenance performed by unqualified personnel could result in a risk of injury. 24. When servicing a tool, use only identical replacement parts. Follow instructions in the “Inspection, Maintenance, And Cleaning” section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury. SPECIFIC SAFETY RULES 1. Maintain labels and nameplates on the Hoist. These carry important information. If unreadable or missing, co

2010 / / 73 3 23 English 1 - 10 Deutsch 11 - 20 Francais 21 - 30 Espanol 31 - 40 Italiano 41 - 50 Guarantee 51 - 54 EL-Skyport Transmitter Speed 19350 English Contents : Features 2 Battery Installation 3 Hot-shoe connector 3 Operating Instructions 3 Frequency Channel 4 Trigger Modes 5 Integrated SYNC Socket 6 Elinchrom RX Features 6 EL-Skyport Modules 8 Troubleshooting 9 CE Statements 9 FCC Compliance and Advisory Statement 10 Disposal and recycling 10 EL-Skyport Transmitter SPEED//19350 Operati

FAILURE TO CAREFULLY READ AND UNDERSTAND THE FOLLOWING INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR DEATH TO THE SCBA USER. USE OF A RESPIRATOR INTEGRATED WITH THE SEMS USER ACCOUNTABILITY SYSTEM WILL REQUIRE MODIFICATION OF THE RESPIRATOR "REGULAR OPERATIONAL INSPECTION PROCEDURES" AND WILL REQUIRE TRAINING OF THE RESPIRATOR USER IN THE USE OF SUCH RESPIRATORS. THE FOLLOWING INSTRUCTIONS SUPPLEMENT BUT DO NOT REPLACE THE OPERATING AND MAINTENANCE INSTRUCTIONS SUPPLIED WITH EACH RESPIRATOR. 1 WA