On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. A plug and jack used to connect this HA30 / HA40 to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug, RJ11 USOC, is provided with this product. It is designed to be connec

IMPORTANT: Always disconnect HA 30/40 from the telephone before replacing the battery! 2 Installation: 1. Unplug the handset cord from your telephone base. Insert this plug into the jack at the front of the Handset Amplifier. 2. Connect the Handset Amplifier to your telephone base as shown. 3. Pick up the handset. If there is a dial tone, you have installed the Handset Amplifier correctly. Volume Control Adjust the volume to the most comfortable listening level by moving the volume control slide

• Setup special features Installing the Backup Batteries To add extra brightness to the Dialogue XL-25s’s ring flasher when you receive calls, install one 9 Volt alkaline battery (not included). Note: For your safety always unplug the phone line before you install or replace the backup battery. 4 Figure 3 To install new battery: 1. Slide open the battery compart-ment cover on the bottom of the telephone, (Figure 3). 2. Install one fresh 9-volt battery. The battery indicator on the base unit will

SAVE THESE INSTRUCTIONS Contents Introducing the Dialogue XL-25s ............................................................2 Warranty Service ......................................................................................2 Sales Receipt ............................................................................................2 Help from Ameriphone................................................................................2 Features .................................................

Help from Ameriphone For help with using your DIALOGUE JB-20 , call our Customer Relations department at 800-894-3005. Please make sure your DIALOGUE JB-20 package includes the items shown in Figure 1. Base Unit CHAPTER 3 FEATURES IDENTIFICATION RINGER TONE selector HOLD button Ringer control switch (volume) Audio Output jack Tone / Pulse switch Emergency buttons Braille characters Raised letters for easy identification REDIAL button MEMORY button HANDSET VOL control (volume) FLASH button PROG b

3. Press the MEMORY b button and then the desired MEMORY button (Figure 24) to store this number as the second phone number in the same memory location. Making and Answering VCO Calls A person with hearing loss who uses their voice can use voice carry over (VCO) through the toll-free local relay service to communicate with a hearing person. In a VCO (voice carry over) call, the hard of hearing person speaks directly to the other party. The Communications Assistant (CA) relays the response from t

When AMPLIFY is on, the AMPLIFY indicator comes on. P E0 # HOLD PROG TONE LO HI FLASH REDIAL VOL AMPLIFY * Figure 8 - AMPLIFY Button and Indicator 2. Adjust the volume in the ear piece by moving the VOL slide control in Figure 9. With AMPLIFY on, incoming volume will be up to 48dB louder. Caution: Repeated incremental exposure to amplification levels greater than 18 dB may be harmful to individuals without hearing disabilities. Therefore, do not remove the warning label attached to the back of t

Read and understand all instructions. Observe all warnings and other markings on the product. 2. During thunderstorms, avoid using telephones except cordless models. There may be a slight chance of electric shock from lightning. 3. Do not use a telephone near a gas leak. If you suspect a gas leak, report it immediately, but use a telephone away from the area where gas is leaking. 4. Do not use this product near water, or when you are wet. For example, do not use it in a wet basement or shower, o

1. Insert four AA alkaline batteries for back-up in case of AC power outage. 2. Decide if you want the phone to sit on a desk or hang on the wall. 3. Connect the telephone components. 4. Program up to 12 telephone numbers to call with the press of a memory button. 5. Set up special features Installing the Backup Batteries If there is a power outage, the XL-50 will operate for up to 48 hours with four AA alkaline backup batteries (not included). If the phone is not in use, the batteries will stay

12082 Western Avenue, Garden Grove, CA 92841 (800) 874-3005 VOICE • (800) 772-2889 TTY/TDD (714) 897-4703 FAX email: ameriphonecs@plantronics.com website: ® ALERTMASTER® AM-RX2 REMOTE RECEIVER Users’ Guide E S P A N O L F R A N C A I SE N G L I S H AM100 M08298 .A 4/03 Contents Important safety Instructions ........................................1 Installation .................................................................8 Operations...........................................................