Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
• The appliance must be switched off before plugging it in or unplugging it. • This vacuum cleaner must not be used without the dust bag and filters. This could damage theappliance. • Do not handle either the vacuum or the plug with wethands. Do not immerse the appliance in water. • This appliance can beused by children aged from 8 years and aboveand persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they havebeen given supervision or instruction concerning useof the appliance in a safe way and understand thehazards involved. Children shall not play with theappliance. Cleaning and user maintenance shall not be made by children without supervision. • Read these instructions carefully. Safeguard them for future reference. • This appliance has been designed exclusively for domestic use. It must only be used in accordance with these instructions. The manufacturer will not be held any responsibility for any damage caused by improper use or incorrect operation. • Do not use the vacuum cleaner on people or animals. • Do not expose the vacuum cleaner to outdoor weather conditions, dampness or heat. Do not leave the vacuum cleaner beside hot ovens, heaters or radiators. • Before plugging the appliance into the mains supply, make sure that the voltage corresponds to that stated on rating plate. • Do not operate the appliance with the cable still coiled. • Do not unplug the appliance by tugging on the cable. • Unplug the vacuum cleaner from the mains supply when not in use and before proceeding to clean it or change the bags or filters. • Never use the vacuum cleaner without a bag, or try to empty a full bag and reuse it. • Do not use the vacuum cleaner if it is blocked, as this will reduce the air flow causing it to overheat, which may damage the appliance. • Do not pull on either the cable or the suction tube to move the vacuum cleaner. Use the carrying handle. • Do not use the appliance if either the cable or plug is damaged or if it can be detected that the appliance is not working correctly. • When closing doors, make sure not to pinch the cable. • At the end of its life, the vacuum cleaner should be disposed of in an appropriate manner. • If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. • ATTENTION: Do not use the vacuum cleaner to suck up building waste (cement, brick dust, rubble, etc.). These types of particles quickly clog up the pores in the dust bag causing the appliance to overheat. SWITCHING ON AND OPERATION -Insert the hose (3) into the suction hole (6) so that it clicks into position. Pressing down the release button will help you remove the hose (3). (Fig. 1) -Attach the telescopic tube (2) to the handgrip (4), and adjust the length to suit the user. (Fig. 2) - Fit the floor brush (1), accessory number 18, 19, 20 to the vacuum tube (Fig. 3). The accessary parts 18, 19, 20 can also be affixed to the handgrip (4) (Fig. 4). -Holding the power cord by the plug, pull out the required length and plug it into the mains socket. (Fig. 5) -Press the On/Off pedal (7), (Fig. 6). Regulate the power using the power regulator (8), and push it from “-” to “+” to increase power while pushing it from “+” to “-” to reduce power (Fig. 7). The intensity can be regulated from the handgrip. Opening the flap (5) reduces suction, whereas closing it increases suction. (Fig. 8) -You can use the parking aid on the back of the vacuum cleaner if you wish to stop vacuuming for a short while. Slide the catch on the brush into the groove at the rear of the appliance (Fig. 9). -The wheels and 360° swivel joint and the carrying handle (11) make this vacuum cleaner extremely mobile. WHEN FINISHED When you have finished using the appliance, set the power regulator (8) to the minimum position and press the On/Off pedal. Press the automatic cable rewind pedal (9) to wind the cable back (Fig. 10). Clip the tube onto the vacuum cleaner in a vertical position (Fig. 11). REPLACING AND MAINTAINING Bag full indicator (10) When suction power decreases considerably and the bag full indicator lights up. This means that the dust bag (16) is full or that the hose, tube or filters are blocked. If this occurs, follow the instructions for changing the dust bag, cleaning the filters and unclog hose or tube. Changing the dust bag (16) -Open the cover following the direction of the guide-arrow. (Fig. 12) -Take the dust bag out of the dust bag holder (17). (Fig. 13) -Insert the bag into the bag holder, following the direction of the guide-arrow. Make sure that it slots fully down into its housing and that it fits correctly. Close the cover. Important: • The cover can not be closed if there is no bag fitted. Do not force it shut, check that the bag is fitted correctly. • If the suction is irregular and the bag full indicator stays lit, check that there is nothing blocking the hose, tube or air inlet. Cleanin...