Log:
Évaluations - 3, GPA: 4 ( )

Instructions Electrolux, Modèle CycloneXL

Fabricant : Electrolux
Taille : 1.12 mb
Nom Fichier : 5d1f528a-7692-4154-9847-5f6c0fef8a9e.pdf
Langue d'enseignement: en
Aller à la télécharger



Facilité d'utilisation


This means that with your specific model, some accessories/ features may not be included. In order to ensure the best results, always use original Electrolux accessories. They have been designed especially for your vacuum cleaner. 1 2 3 4 5 6 7 8 9 10 Safety precautions CycloneXL should only be used by adults and only for normal vacuuming in a domestic environment. The vacuum cleaner features double insulation and does not need to be earthed. Disconnect the plug from the mains before cleaning or maintenance of the vacuum cleaner. Be sure to keep the vacuum cleaner in a dry place. All servicing and repairs must be carried out by an authorised Electrolux service centre. Never vacuum: • In wet areas. • Close to flammable gases etc. • When housing shows visible signs of damage. Never vacuum: • Sharp objects, fluids. • Hot or cold cinders, lit cigarette butts, etc. • Fine dust, for example from plaster, concrete, flour, hot or cold ashes. The above may cause serious damage to the motor – damage which is not covered by the warranty. Electrical cable precautions: Regularly check that the cable is not damaged. Never use the vacuum cleaner if the cable is damaged. Damage to the machine’s cable is not covered by the warranty. Accessories 1* Telescopic tube 2* Extension tubes 3 Hose handle + hose 4 Combination floor nozzle 5 Crevice nozzle 6 Upholstery nozzle 7 Accessories clip 8* Turbo nozzle 9* Parquet nozzle 10* Feather duster * Certain models only. Before starting 11 Open the front cover on the machine and check that the motor filter and the dust container filter are in place. (See also Cleaning/replacing the filters.) 12* Open the back lid on the machine and check that the exhaust filter is in place. 13 Insert the hose until the catches click to engage (press the catches to release the hose). 3 Insert the hose into the hose handle until the catches click to engage (press the catches to release the hose). 14 Attach the extension tubes* or telescopic tube* to the hose handle and nozzle by pushing and twisting together. (Twist and pull apart to dismantle.) 15 Extend the electric cable and connect it to the mains. The vacuum cleaner is fitted with a cable winder. Once the electric cable has been extended, it stays in that position. 16 To rewind the cable, press the cord rewinder pedal. The cable will then rewind. 17a Start the vacuum cleaner by rotaring the power control in the direction of the “Max” position. Increase suction power by rotaring the control further up to “Max” position. Stop the vacuum cleaner by rotaring in the opposite direction to “Off” position. In order to achieve an optimal cyclone effect in the cleaner, the power regulation should always be in the “Max” position. 17b* Suction power can also be adjusted by using the suction control on the hose handle. 18 Ideal parking position for pausing (18a) and storing (18b). * Certain models only. 11 12 13 15 16 17a 14 18a 18b 17b Getting the best results Use the nozzles as follows: Carpets: Use the combination floor nozzle with the lever in position (19). Hard floors: Use the combination floor nozzle with the lever in position ( 0). Wooden floors: Use the parquet nozzle* ( 1). Upholstered furniture and fabrics: Use the upholstery 19 20 nozzle* ( ) for sofas, curtains, lightweight fabrics etc. Reduce suction power if necessary. Frames, bookshelves, etc.: Use the feather duster* ( ). Crevices, corners, etc.: Use the crevice nozzle* ( ). Using the turbo nozzle* / 6 Ideal for carpets and wall-to-wall carpeting to remove stubborn fluff and pet hairs. Note: Do not use the turbo nozzle on skin rugs or carpet fringes. To avoid damaging the carpet, do not keep the nozzle stationary whilst the brush is rotating. Do not pass 21 22 the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use. 23 24 25 26 * Certain models only. Emptying and cleaning the dust container CycloneXL’s dust container must be emptied when it is full. 7 Pull the release button at the rear of the vacuum cleaner. 8 Lift the dust container out. 9 Open the lid of the dust container by pressing the release button on the right. 0 Empty it over a wastepaper basket. Put the dust container back ( 1) and press the rear part of the container until it clicks into place. Every now and then the dust container should be cleaned. Remove lids at both ends and rinse the container in water or machinewash it. Remove particles that may be stuck in the cone. * Certain models only 27 28 29 30 31 32 7 33 34 36 37 38 35 * Certain models only. Cleaning the motor filter and the dust container filter CycloneXL has a motor filter and a dust container filter that should be cleaned now and then. 33 Open the front lid and lift out the dust container. 34 Dust container filter: Remove the filter holder from the dust container and carefully pull the dirty dust container filter out of the holder. 35 Motor filter: Pull the filter upwards until coming away from the groove. 36 Rinse the filt...


Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories