Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
6 ESpanol 6 Suomi 76 FrancaiS 89 italiano 10 nEDErlanDS 117 norSk 1 1 portugueS 1 SvEnSka 159 turkcE 17 SCD 469 6 introduction EngliSh 6 introduction EngliSh Philips is dedicated to producing caring, reliable products to give parents the reassurance they need. This baby monitor consists of a parent unit and a baby unit. It provides round-the-clock suppor t by ensuring that you can always hear your baby clearly. When the units are connected properly, you have the cer tainty that you can hear your baby wherever you are in or around your home or garden. When the regular baby monitor is out of range, simply connect it to your phone or mobile phone. Philips Baby Care: taking care together general description (Fig. 1) a Baby unit 1 M (memor y) button 2 CHANNEL selection slide 3 SENSITIVITY slide 4 Nightlight button Q 5 Keypad -pin press this button to enter a PIN code. -prg (program button) press this button to enter the program mode. -O press this button to set the sensitivity time. With this button you can also include a pause when you enter a telephone number. -C (clear button) press this button to clear the last input. 6 Microphone 7 POWER button 8 Power light 9 Display-A unit in regular baby monitor mode -Aunit in dial-up mode -E indicates phone numbers stored in the memor y (M1-M5) -N indicates phone numbers -Uunit not/not properly connected to the mains or running on batteries -C unit not connected to the telephone network -O indicates that a non-default sensitivity time has been programmed (the default sensitivity time is 10 seconds) -a indicates that a PIN code has been programmed -T indicates the batter y status. As the energy level inside the batteries drops, the number of segments shown decreases.The batter y symbol blinks when the batteries are low and need to be replaced. 10 MODE button 11 Keypad cover 12 RESET button 13 VOLUME control 14 TONE/PULSE selector 15 Loudspeaker 16 Extendable and turnable antenna 17 Phoneline-out socket 18 Phoneline-in socket 19 Socket for small plug 20 Batter y compar tment lid 21 Adapter with small plug Not shown: telephone cable and plug B Parent unit 1 Charging light EngliSh 2 Charger 3 SYSTEM CHECK light 4 Loudspeaker 5 Sound level lights 6 Antenna 7 POWER light 8 VOLUME control with off position 9 CHANNEL selection slide 10 Socket for small plug 11 SYSTEM CHECK ALARM switch 12 Batter y compar tment 13 Batter y compar tment lid 14 Adapter with small plug important Read these instructions for use carefully before you use the appliance and save them for future reference. , , ,, , , ,, , ,,,,,,,, , ,, This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult supervision and should not be used as such. Check if the voltage indicated on the adapter corresponds to the local mains voltage before you connect the appliance. The appliance is suitable for mains voltages from 0 to 0V. Except for the battery compartments, do not open the housing of the baby unit and parent unit to prevent electric shock. If the adapter of the baby unit or the parent unit is damaged, always have it replaced by one of the original type to avoid a hazard. If the charger of the parent unit is damaged, always have it replaced by one of the original type to avoid a hazard. Use and store the appliance at a temperature between 10°C and 0°C. Do not expose the baby monitor to extreme cold or heat or to direct sunlight. (Fig. ) Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/ feet away). Do not place the baby unit inside the baby’s bed or playpen. Do not use the baby monitor in moist places or close to water. Do not cover the baby monitor with a towel or blanket. Do not immerse any part of the baby monitor in water or any other liquid. Always place batteries of the correct type in the baby unit to avoid the risk of explosion. Always replace the rechargeable battery pack of the parent unit with one of the correct type. Only use the adapter supplied to connect the baby unit to the mains. Only use the charger supplied to charge the parent unit. The adapters contain a transformer. Do not cut off the adapters to replace them with other plugs, as this will cause a hazardous situation. Since continuous transmission is prohibited, you only hear your baby when it makes sounds. The antenna of the parent unit is fixed. Do not pull at the antenna or bend it. The antenna of the baby unit can be pulled out and turned upwards. preparing for use , Baby unit You can use the baby unit from the mains or on batteries. Even if you intend to use the unit from the mains, we advise you to inser t batteries.This guarantees automatic back-up in case of mains failure. EngliSh mains operation 1 Put the small plug in the socket on the baby unit and insert the adapter in a wall socket. (Fig. ) Battery operation The baby unit runs on four 1.5-volt R6 AA batteries (not included). We strongly advise you to use Philips LR6 PowerLife batteries. Make sure your h...
Ce manuel est également adapté pour les modèles :Bébé - SCD469/84 (1.27 mb)