Évaluations - 2, GPA: 4
(
)
)
|
Facilité d'utilisation
Press the Button to play it. 2. When an iPhone/iPod is docked and in standby mode, press the Button to play it. “iPod” will appear briefly in the lower part of the display to show iPod is currently in play mode. 3. Press the Button again to pause play; press again to resume it. 4. Turn the Volume Wheel to adjust the system volume. 5. Press the EQ Button to select and turn the Set Wheel to adjust Treble, Bass, and Left/Right Balance. 6. To turn off the unit, press the Button. An iPhone/iPod will continue charging while docked. Listening to FM Radio Setting up the Antenna Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas. Tuning and Playing the Radio 1. Press the Radio Button to turn on the iP43. 2. Turn the Set Wheel to tune the radio to a desired FM station. The current radio frequency appears in the lower part of the display. 3. Turn the Volume Wheel to adjust the system volume. 4. Press the EQ Button to select and turn the Set Wheel to adjust Treble, Bass, and Left/Right Balance. 5. To turn off the unit, press the Button. 7 To memorize a station as a preset 1. In Radio mode, turn the Set Wheel to select a station. 2. Press and hold the desired Preset Button until the odd number preset (P1, P3, P5) flashes on the display; press again to assign the station to the related even number preset (P2, P4, P6). Allow to time-out. You will hear a beep confirming the preset has been assigned. To change presets, repeat steps 1 and 2. To access a preset station 1. At any time, press the desired Preset Button once to listen to odd number presets or twice for even number presets. Sleep mode, Dimmer and more Sleep Operation Sleep mode lets you sleep to your iPhone/Pod or radio, gradually lowering the volume until the unit shuts off at the selected time. 1. Press the Sleep Button to enter sleep mode. The sleep time will show in the lower display. 2. Press the Sleep Button again as needed to adjust the sleep timer from 120, 90, 60, 30 or 15 minutes. 3. When the display changes back to show the real time, press the Sleep Button once to show the sleep time remaining. Pressing it again will change sleep time to next lowest increment. 4. iP43 has independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the normal volume. The sleep volume will remain at that level the next time you enter sleep mode until controls are changed. 5. To stop listening at any time, press the Button to turn unit off. Dimmer Operation During normal operation, press the Snooze/Dimmer Button to control the brightness of the LCD display. Using the iP43 in Other Countries Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you live in the US, you may skip this section. 1. Make sure the iP43 is OFF (not playing in any mode). Press and hold the Radio Button for about 5 seconds until “USA” appears in the lower part of display. Turn the Set Wheel to adjust country frequency to your region. 2. Press the Radio Button again (or no button within 5 seconds) to exit the radio frequency setting mode. 8 A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings. 3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat. 4. Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket. 6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning instructions....
Ce manuel est également adapté pour les modèles :récepteurs radio - IP43 IP43 (343.39 kb)