Log:
Évaluations - , GPA: ( )

Instructions Eton, Modèle FR600

Fabricant : Eton
Taille : 778.97 kb
Nom Fichier : FR600_Manual_030509.pdf

Langue d'enseignement: enesfr

Le document est chargé, s'il vous plaît patienter
Le document est chargé, s'il vous plaît patienter


Par ce dispositif a également d'autres instructions :

Facilité d'utilisation


One group of sockets is for the rechargeable Ni-MH batteries and the other group of sockets is for the AA batteries. Install 3 AA batteries and set the power selector switch to the BATTERY position. SOLAR POWER When you’re in sunlight set the power switch to the SOLAR position. This position also recharges the Ni-MH rechargeable battery. Note: The rechargeable Ni-MH batteries have been disconnect for transportation purposes. To use the crank-charge system, open the battery compartment cover and connect the rechargeable batteries’ plug into its socket. DYNAMO POWER The rechargeable Ni-MH (nickel-metal-hydride) battery is in the battery compartment. To use it plug the battery into the socket adjacent to it, then set the power switch to the DYNAMO position. You may have to charge the battery; to do this turn the crank for 90 seconds. The rechargeable battery will eventually lose its ability to hold a charge. SOLARLINLK FR600 OWNER’S MANUAL DC-IN 5V ADAPTOR (not included) This socket is located on the back of the radio, under the rubber plugs. Plug in the AC adapter to the DC IN 5 volt socket. This also charges the Ni-MH battery. DC-IN USB COMPUTER SOCKET (USB cord not included) This socket is located on the back of the radio, under the rubber plugs. Plug in the USB cord to the DC IN socket. This also charges the Ni-MH battery. VOLUME CONTROL Turning the Volume Adjusting Knob (located on the lower right of the radio) clockwise turns up the volume; counterclockwise turns down the volume. Always turn down the volume before using earphones. CHARGING CELL PHONES (cell phone charging cord included) If you revolve the Power Supply Knob to the OFF/PHONE CHARGER position the radio will charge cell phones. Plug the cell phone charging cord into the USB PHONE CHARGER jack at the rear of the radio. Plug the cell phone charging adapter tip into the other end of the cord and then into the jack of the cell phone. Then put the radio in the sun or revolve the hand crank to charge the cell phone. About 10 minutes of cranking results in one or two short emergency calls. NOTE: When charging a cell phone via the USB cell phone charger, it is important to turn the crank at least 2 revolutions per second, or until you see the green or orange LED above the crank handle SOLARLINLK FR600 OWNER’S MANUAL turn on. This is an indication that the phone is receiving enough power from the radio. Continue to crank at this rate until you are satisfied that an appropriate level of charge has been received by your cell phone. If you decide to stop cranking for whatever reason, please wait at least 5 seconds before beginning to crank again. Not following these instructions may cause damage to your cell phone for which Eton disclaims any liability and will not be held liable for any actual or consequential damages related to this matter. SETTING THE DATE 1. Revolve the to the “OFF” position. 2. Press

button shortly to enter the setting menu. 3. Press <.> or <.> shortly to select “SET UP---DATE” option. 4. Press shortly to save. SOLARLINLK FR600 OWNER’S MANUAL SETTING THE CLOCK 1. Revolve the to the “OFF” position. 2. Press button shortly to enter the setting menu. 3. Press <.> or <.> shortly to select “SET UP---TIME” option. 4. Press shortly to save. Note: The clock is a 12-hour clock, showing “AM” in the display in the morning, and showing “PM” in the display starting at noon. SETTING THE BEEPER ALARM This radio’s alarm beeps when it activates. 1. SETTING THE ALARM TIME 1) Revolve the to the “OFF” position. 2) Press button shortly to enter the setting menu. SOLARLINLK FR600 OWNER’S MANUAL 3) Press <.> or <.> shortly to select “SET UP ALARM--ALM” option. 4) Press shortly to save. 2. ACTIVATING AND DEACTIVATING THE ALARM Press shortly to activate or deactivate the alarm. If the alarm function is activated, the alarm symbol “ .AL” and alarm time will appear in the display. When the alarm time is reached, the unit will beep. If the alarm function is deactivated, the alarm symbol “.AL “ and alarm time will disappear from the display. SOLARLINLK FR600 OWNER’S MANUAL 3. SNOOZE BUTTON When the alarm activates, pressing the button shortly deactivates it for 5 minutes (“ “ appears in the display), then it starts again. BROADCAST R...

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories