|
Facilité d'utilisation
6,6 cm Durchmesser, 8 . Ausgangsleistung 120 mW (bei 10 % Klirrgrad) Stromversorgung Nord- und Sudamerika: 120 V Wechselspannung, 60 Hz Australien: 240 V Wechselspannung, 50 Hz Andere Lander: 220 - 230 V Wechselspannung, 50 Hz Zur Stromausfalluberbruckung: Batterie des Typs 6F22, 9 V Gleichspannung Nord-und Sudamerika Andere Lander Italien Stand Support Stander To display minute and second, press SNOOZE. Example: When the current time is 7:15:10, the display will become: 7 :15 , 5 :10 Lower of minute digit Second digits The display returns to the current time when you release SNOOZE. To adjust the time exactly to the second, press + briefly with the time signal. Operating the Radio 1 Press RADIO ON to turn on the radio and adjust VOL (Volume). 2 Select FM, AM (MW) or LW and tune in to a station using TUNING. To turn off the radio Press ALARM RESET•RADIO OFF. Improving the Reception FM: Extend the FM wire antenna fully to improve FM reception. AM (MW)/LW: Rotate the unit horizontally for optimum reception. A ferrite bar antenna is built into the unit. Setting the Alarm This radio is equipped with 3 alarm modes – RADIO, BUZZER and RADIO+BUZZER. Before setting the alarm, make sure to set the clock (see “Setting the Clock”). To set the radio alarm, first tune in to a station and adjust the volume. 1 Set the ALARM TIME/CLOCK SET switch to RADIO or BUZZER. 2 Press FAST+, FAST– or + to select the desired time. When you press FAST+, the time is raised rapidly. When you press FAST–, the time is lowered rapidly. When you press +, the time is raised in oneminute steps. 3 Set the ALARM TIME/CLOCK SET switch to HOLD. Make sure that the ALARM TIME/CLOCK SET switch is set to HOLD after setting the clock. When it is set to HOLD, you cannot see the red label underneath. 4 Set the ALARM MODE switch to RADIO, BUZZER or RADIO+BUZZER. The ALARM RADIO or ALARM BUZZER indicator lights up. When you set both alarm times, both ALARM RADIO and ALARM BUZZER indicators light up. The alarm will come on at the preset time and will automatically turn itself off after about 59 minutes. If the same alarm time is set for both RADIO and BUZZER, RADIO will take priority. To check the alarm setting Set the ALARM TIME/CLOCK SET switch to RADIO or BUZZER. To Doze for a Few More Minutes Press SNOOZE. The radio or buzzer turns off but will automatically come on again after about 6 minutes. You can repeat this process as many times as you like. To Stop the Alarm Press ALARM RESET•RADIO OFF to turn off the alarm. The alarm will come on again at the same time the next day. To Deactive the Alarm Set the ALARM MODE switch to OFF. ALARM RADIO, ALARM BUZZER or both indicators will be turned off. To Adjust the Alarm Level (BUZZER VOLUME) Adjust the loudness of the alarm by setting BUZZER VOLUME to (Quiet), (Normal), or (Loud). Note If you select the RADIO+BUZZER mode, set the BUZZER alarm time earlier than the RADIO alarm time, and then use the SNOOZE button to turn off the buzzer, the radio will not come on even if the RADIO alarm time comes during the snooze period; only the buzzer will come back on after the snooze period is over. Setting the Sleep Timer Enjoy falling asleep to the radio using the built-in sleep timer. Press SLEEP. The radio turns on. You can set the sleep timer to durations up to 59 minutes. When you keep pressing SLEEP, the time is lowered in one-minute steps. When you press FAST+ or FAST– while holding down SLEEP, the time is changed rapidly. When you press + while holding down SLEEP, the time is raised in one-minute steps. The radio will play for the time you set, then turn off. To turn off the radio before the preset time Press ALARM RESET•RADIO OFF. Precautions • Operate the unit on the power source specified in “Specifications”. • The nameplate indicating operating voltage, etc. is located at the rear of the unit. • To disconnect the power cord (mains lead), pull it out by the plug, not the cord. • The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet even if the unit itself has been turned off. • Do not leave the unit in a location near a heat source such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. • Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, a blanket, etc.) or near materials (a curtain) which might block the ventilation holes. • Should any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further. • To clean the casing, use a soft cloth dampened with a mild detergent solution. • Do not connect the antenna lead to an external antenna. Battery Warning When the unit will be left unplugged for a long time, remove the battery to avoid undue battery discharge and damage to the unit from battery leakage. If you have any questions or problems concerning your unit, pleas...
Ce manuel est également adapté pour les modèles :récepteurs radio - ICF-C490 (293.29 kb)