|
Facilité d'utilisation
While in a menu, press to cancel an operation, back up to the previous menu, or exit the menu display. MENU/SELECT Press to enter the main menu (page 7). Press to select, save, or set a desired setting. CELLULAR Press to make or answer a CELLULAR call. Flashes when there is an incoming CELLULAR call or when a CELLULAR call is on hold. Quick launch keys When in idle mode, press one of the NavKeys to launch a handset feature: • Settings (UP) • Directory (DOWN) • Intercom (LEFT) • Messages (RIGHT) Status light Flashes rapidly during an incoming call, and when there is a new voice mail message or new message in the answering system. Softkeys (2) Press to select a menu item displayed just above the key. HOME/FLASH Press to make or answer a HOME call. Flashes.................... rapidly when there is an incoming HOME call. and when a HOME call is on hold. SPEAKER Press to activate the handset speakerphone. The SPEAKER key is lit when the speakerphone is on NavKeys (in brackets) Press the UP, DOWN, LEFT or RIGHT NavKeys to navigate through the menus, highlight items, and change settings. 12:00AM HANDSET 1 CALLER ID REDIAL Settings (UP) Int'com (LEFT) Msgs. (RIGHT) Directory (DOWN) Handset main menu To enter the main menu: 1. Press MENU/SELECT when the handset is in idle mode. 2. Press the UP and DOWN Navkeys to select a handset feature menu, then press MENU/SELECT to enter that menu. To return to the idle mode, press and hold OFF/CANCEL. Settings allows you to change your handset settings. Directory allows you to store and search for names and numbers. Directory Settings Settings Call Log allows you to review your most recent incoming calls. Ringers allows you to setup ringers for the HOME and CELLULAR lines. Ringers Call Log Messages allows you to review your answering system messages. Pictures allows you to set the wallpaper. Messages Pictures Intercom allows you to page the telephone base and other handsets. Animations allows you to choose animated wallpapers. Animations Intercom Belt clip & optional headset Install belt clip as shown below, if desired. For handsfree headset conversations, use any industry standard 2.5 mm headset (purchased separately). For best results, use an AT&T 2.5 mm headset. To purchase a headset, visit our website at or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268. To release the belt clip from the handset, press on both flaps of the belt clip (as shown). Pull and unlock one flap from the notch first before detaching the whole belt clip from handset. Snap the belt clip into the notches on both sides of the handset. Lift the rubber flap here. Plug a 2.5 mm headset into the jack on the side of the handset. Side of the handset Appendix Troubleshooting If you have difficulty with your telephone, please try the suggestions below. For complete instructions, please refer to the user’s manual provided with your EP5632/EP5632-2 telephone system, which can be downloaded from our website at or call 1 (800) 222–3111. In Canada, dial 1 (866) 288-4268. • Make sure the handset battery is installed and charged correctly. For optimum daily performance, return the cordless handset to the telephone base after use. • Make sure the power adapter is securely plugged into an outlet not controlled by a wall switch. • Make sure the telephone line cord is plugged firmly into the telephone base and the modular wall jack. • Reset the telephone base. Unplug the unit’s electrical power. Wait for approximately 15 seconds, then plug it back in. Allow up to one minute for the cordless handset and base to reset. • It may be necessary to purchase a new battery. Please refer to the battery section of this user’s manual. My telephone does not work at all. • Only one handset can be registered at a time. If you have multiple handsets to register, please follow the steps on page 4 for the first handset. Once a handset has been successfully registered, repeat the steps for each handset that needs to be registered. • Make sure that the telephone base and handset(s) are in idle mode when registering a handset. Pick up the handset from the telephone base or charger then repeat the steps on page 4. • Follow the steps on page 13 for the common cure for electronic equipment. Registration Failure appears on the handset and telephone base display. Appendix 10 The battery does not charge in the handset -OR- Low Battery is constantly displayed on the handset. • Make sure the handset is placed in the charger correctly. The CHARGE light on the charger should be on. • If the cordless handset is in the charger or in the telephone base but the CHARGE light is not on, refer to The CHARGE light is off in the section below. • Remove the battery from the handset and install it in the spare battery compartment on the side of the telephone base and let it charge for 16 hours. Then re-install the charged battery into the handset. • Please refer to the battery section of this user’s manual. •...
Ce manuel est également adapté pour les modèles :Guns - EXPANSION EP5632 (1.68 mb)
Guns - EXPANSION EP5632-2 (1.68 mb)