Log:
Évaluations - , GPA: ( )

Instructions Transition Networks, Modèle SSDTF1022-100

Fabricant : Transition Networks
Taille : 101.43 kb
Nom Fichier :

Langue d'enseignement: en

Le document est chargé, s'il vous plaît patienter
Le document est chargé, s'il vous plaît patienter

Facilité d'utilisation


• Check RJ-45 Pinning Switch for correct twisted pair cable configuration. • Check integrity of device attached to media converter pair cable. • Contact Technical Support: (800) 260-1312/(800) YES • Contact Technical Support: (800) 260-1312/(1 2 3 4 toward network connectors SHORT HAUL Switch Settings* RIGHT SWITCH SET 1 2 3 4 1 2 3 4 toward chassis LONG HAUL Switch Settings* 1 2 3 4 DSX-1 533'-655' 100 ohm cable DSX-1 399’ -533’ 100 ohm cable DSX-1 266’ -399’ 100 ohm cable DSX-1 133'-266' 100 ohm cable DSX-1 1 0’ -133’ and ANSI T1.403 100 ohm cable DSX-1 6.0V 100 ohm cable -22.5db 100 ohm cable -15db 100 ohm cable -7.5db 100 ohm cable 0db 100 ohm cable *Right *Right INSTALLATION (continued) Install Cable COPPER T1 100 OHM (RJ-45 CONNECTOR) 1. Locate or build twisted-pair cables that are compliant with specifications on page 10, with RJ-45 plug connectors at both ends. 2. Ensure that MDI/MDI-X switch is set according to network conditions. 3. Connect RJ-45 plug connector at one end of cable to media converter RJ-45 jack connector. 4. Connect RJ-45 plug connector at other end of cable to network equipment. FIBER 1. Locate or build fiber cables that are compliant with specifications on page 9, with male two-stranded TX to RX connectors installed at both ends. 2. Connect cable with connector installed at TX location on media converter to RX location on attached device. TX RX TX RX 3. Connect cable with connector installed at RX location converter to TX location on attached device. Power the Media Converter 1. Install power adapter cord at back of media 2. Connect power adapter plug to AC power. 3. Verify that media converter is powered LED(s). OPERATION After installation, the media converter should function without operator intervention. Status LEDs Use the status LEDs to monitor media converter operation in the network. SDC Signal Detect/Copper - Steady LED indicates twisted-pair copper link is up. Flashing LED (once/second) indicates transmitting on link if other link is down. Flashing LED (5 times/second) indicates All Ones detected on Link. SDF Signal Detect/Fiber - Steady LED indicates fiber link is up. PWRSDFSDC LOOP Flashing LED (once/second) indicates transmitting on link if other link is down. Flashing LED (5 times/second) indicates All Ones detected on Link. P(o)W(e)R Steady green LED indicates connection to external AC power. ...

Ce manuel est également adapté pour les modèles :
Récepteur et amplificateur - SSDTF1011-100 (101.43 kb)
Récepteur et amplificateur - SSDTF1014-100 (101.43 kb)
Récepteur et amplificateur - SSDTF1012-100 (101.43 kb)
Récepteur et amplificateur - SSDTF1013-100 (101.43 kb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories