|
Facilité d'utilisation
. . 150W 4 ohms, 20Hz-20kHz 1%THD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 250W Bridge Mode 8 ohms, 20Hz-20kHz 1%THD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500W 25, 70, 100 Volt models, 20Hz-20kHz 1%THD, per channel . . . . . . . . . . . . . . . . . . . . . . 250W Signal to Noise (20Hz-20KHz, unweighted) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >98dB Power Requirements (1/8 Power Pink Noise @4 Ohm): . . . . . . . . . . . . . . . . . . . . . . . . . . 360W - 8Ch, 200W - 4Ch Distortion (SMPTE, typical) - 8 ohm load, 10dB below rated power: . . . . . . . . . . . . . . . <0.5% Distortion (THD-N, typical) - 8 ohm load, 10dB below rated power, 20Hz-20kHz: . . . . <0.5% Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20Hz-20kHz, +/-1dB Damping Factor (8 ohm load, <1kHz) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >250 Input Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20K Ohm, balanced Maximum Input Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +21dB Cooling . . . . . . . . . . . . . . temperature dependent speed-controlled axial fan Control Network . . . . . . . onboard, compatible with standard 100MB Ethernet hardware Front Panel Indicators . . per channel: Clip/Mute, -6dB, -12dB, -18dB, Temp, Current, Bridge (per pair) overall: Power, Standby, Protect, Power Switch Disable, Comm Control Surface and Amp LEDs: Level meters are dB below RATED output Attenuators: per channel: front panel, software, offset link group, and remote Input Connections . . . . . Euroblock Output Connections . . . . Euroblock Amplifier Protection inrush current limitation, temperature monitoring, output over-current protection, mains fuses Power Cable Connector 15A Edison Dimensions . . . . . . . . . . .19”W x 3.5”H x 15.5”D (483 x 89 x 394mm) Weight . . . . . . . . . . . . . . .21 lbs (9.53kg) Environmental: . . . . . . . . 40-120 deg. F, (4-49 deg, C) noncondensing Operating Manual -NE Multi Channel Power Amplifiers DSP Specifications Input: . . . . . . . . . . . . . . .Active Balanced, 10 kohms Max Input Level: . . . . . .+21 dBu Dynamics Brick Wall Limiter Threshold: . . . . . . . . . . .-20dBu to +20dBu Ratio: . . . . . . . . . . . . . . .infinite Attack: . . . . . . . . . . . . . . .0.2ms/dB to 50 ms/dB Release: . . . . . . . . . . . . .5ms/dB to 1000ms/dB Compressor Threshold: . . . . . . . . . . .-20dBu to +20dBu Ratio: . . . . . . . . . . . . . . .1.2:1 to infinite Attack: . . . . . . . . . . . . . . .0.2 to 50ms Release: . . . . . . . . . . . . .5ms/dB to 1000ms/dB Detector: . . . . . . . . . . . . .Peak/Average Autoleveler Target Level: . . . . . . . . . -40dBu to +20dBu Action: . . . . . . . . . . . . . . gentle, normal, aggressive, user defined Maximum Gain: . . . . . . .0dB to +15dB Ratio: . . . . . . . . . . . . . . .1.2:1 to 10:1 Threshold Below Target: -30dB to 0dB Gain Increase Rate: . . . . 5ms/dB to 1000ms/dB Hold Time: . . . . . . . . . . .0-6 sec Ducker Ducking Type: . . . . . . . . high/low priority, trigger, filibuster, ducked program Trigger Threshold: -80dBu to +20 dBu Ducking Release: . . . . . . 5ms/dB to 1000ms/dB Ducking Depth: . . . . . . . 0dB to -30dB Gate Threshold: . . . . . . . . . . .-80dBu to +20dBu Range: . . . . . . . . . . . . . .off, 100dB to 0dB Attack: . . . . . . . . . . . . . . .0.2ms/dB to 50 ms/dB Release: . . . . . . . . . . . . .5ms/dB to 1000ms/dB Gain Gain: . . . . . . . . . . . . . . . .off, -50dB to +12dB Gain w/VCA: . . . . . . . . .off, -50dB to +12dB WR-5 Remote Gain: . . . . off, -50dB to +12dB Equalization 31 Band Graphic Filter Type: . . . . . . . . . . . constant Q or proportional Bandwidth: . . . . . . . . . . . 0.499oct to 0.25oct 2, 4, 6, or 10 Band Parametric Filter Types Parametric: Frequency: . . . . . . . . . . .20-20kHz Level: . . . . . . . . . . . . . . .-30dB to +15dB Q Value: . . . . . . . . . . . . .0.016oct to 4oct Hi/Low Shelf 6/12 dB Frequency: . . . . . . . . . . .20Hz-20kHz Level: . . . . . . . . . . . . . . .-15dB to +15dB All Pass Frequency 20Hz-20kHz Variable Q HP/LP Frequency: . . . . . . . . . . .20Hz-20kHz Q Value: . . . . . . . . . . . . .3.047 to 0.267 Notch/Bandpass Frequency: . . . . . . . . . . .20Hz-20kHz Q Value: . . . . . . . . . . . . .92.436 to 0.267 Crossover 2 Way, 3 Way, 4 Way Crossover High Pass/Low Pass Filters Filter Types: Bessel: . . . . . . . . . . . . . .12/18/24/48 dB/oct Butterworth: . . . . . . . . . . 12/18/24/48 dB/oct Linkwitz: . . . . . . . . . . . . .12/24/48 dB/oct Frequency: . . . . . . . . . . . off, 20Hz-20KHz Delay @ 48kHz Sampling Rate Base Delay: . . . . . . . . . .0-256ms Extra Delay: . . . . . . . . . .0-682 ms @ 96kHz Sampling Rate Base...
Ce manuel est également adapté pour les modèles :Récepteur et amplificateur - ne 4250.10p (820.06 kb)
Récepteur et amplificateur - ne 8250 (820.06 kb)
Récepteur et amplificateur - ne 8250.10 (820.06 kb)
Récepteur et amplificateur - ne 8250.25 (820.06 kb)