Évaluations - , GPA: ( )

Instructions Kenwood, Modèle VR-50RS

Fabricant : Kenwood
Taille : 1.07 mb
Nom Fichier :

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Par ce dispositif a également d'autres instructions :

Récepteur et amplificateur - VR-50RS (1.09 mb)

8 No sound is produced during playback from a DVD player. • The input mode is set to digital manual mode. • Press the INPUT MODE key to select to full auto mode. 8 A video source cannot be recorded normally. • The software is copy-guarded. • Copy-guarded video software cannot be recorded. Tuner Symptom Cause Remedy Radio stations cannot be received. • No antenna is connected. • The broadcast band is not set properly. • The frequency of the desired station is not tuned. • Connect an antenna. % • Set the broadcast band properly. • Tune the frequency of the desired station. . Interference. • Noise due to ignition of an automobile. • Noise due to interference from an electric appliance. • Noise due to a nearby TV set. • Install the outdoor antenna away from the road. • Turn off the power to the appliance. • Install the receiver farther away from the TV. A station which was preset cannot be received by pressing the corresponding numeric key. • The preset station belongs to a frequency that cannot be received. • The preset memory was cleared because the power cord had been unplugged for a long period of time. • Preset a station with a receivable frequency. • Preset the station again. 30 EN In case of difficulty Remote control unit Symptom Cause Remedy Remote control operation is not possible. • The remote control is set to the DVD player operation mode. • Batteries are exhausted. • The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle between the receiver and the remote. • The remote control has not been changed to the operation mode for the KENWOOD DVD player you wish to control. • Press the any of the Input Selector keys to select the appropriate operation mode. • Replace with new batteries. • Operate the remote control unit within the controllable range. • Press the CD/DVD key or DVD key to activate the operation mode for the KENWOOD DVD player you want to control before operation. . 31 EN Caution : Read this page carefully to ensure safe Specifications operation. AUDIO section Rated power output during STEREO operation 100 watts per channel minimum RMS, both channels driven, at 8.from 40 Hz to 20 kHz with no more than 0.7% total harmonic distortion. (FTC) Effective power output during SURROUND operation FRONT (40 ~ 20 kHz, 0.7% T.H.D., at 8. one channel driven) ............................................................................... 100 W + 100 W CENTER (40 ~ 20 kHz, 0.7% T.H.D., at 8. one channel driven) .............................................................................................. 100 W SURROUND (40 ~ 20 kHz, 0.7% T.H.D., at 8. one channel driven) ............................................................................... 100 W + 100 W SURROUND BACK (40 ~ 20 kHz, 0.7% T.H.D., at 8. one channel driven) (VR-60RS) ............................................................... 100 W Total harmonic distortion ........................... 0.05% (1 kHz, 50 W, 8.) Frequency response (IHF‘66) CD/DVD ...................................... 20 Hz ~ 70 kHz, +0 dB, –3.0 dB Signal to noise ratio (IHF’66) CD/DVD ................................................................................. 95 dB Input sensitivity / impedance CD/DVD, DVD, AUX, MD/TAPE, VIDEO 1, VIDEO 2 .............................................................................. 550 mV / 47 k. Output level / impedance MD/TAPE REC ....................................................... 550 mV / 1 k. PRE OUT (SUBWOOFER) ...................................... 1.5 V / 2.2 k. PRE OUT (SURROUND BACK) .............................. 1.5 V / 2.2 k. Tone control BASS ................................................................ ±10 dB (at 100 Hz) TREBLE ............................................................ ±10 dB (at 10 kHz) Loudness control VOLUME at -30dB level ................................... +8 dB (at 100 Hz) DIGITAL AUDIO section Sampling frequency ...................... 32 kHz, 44.1 kHz, 48 kHz, 96 kHz Input level / impedance / wave length Optical ........................... (–15 dBm ~ –21 dBm), 660 nm ±30 nm Coaxial ................................................................... 0.5 Vp-p / 75 . VIDEO section VIDEO inputs / outputs VIDEO (composite) ................................................. 1 Vp-p / 75 . COMPONENT VIDEO inputs/outputs (VR-60RS) COMPONENT VIDEO (luminance signal) ............. 1 Vp-p / 75 . COMPONENT VIDEO (CB/CR-signal) ............... 0.64 Vp-p / 75 . FM tuner section Tuning frequency range................................. 87.5 MHz ~ 108.0 MHz Usable sensitivity MONO......1.3 .V (75 .)/ 13.2 dBf (75 kHz DEV., SINAD 30 dB) 50dB quieting sensitivity STEREO ..................................................... 28 .V (75 .)/ 40.2 dBf Total harmonic distortion (1 kHz) MONO..........................................................0.5% (71.2 dBf input) STEREO ....................................................... 0.7% (71.2 dBf inp...