Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Récepteur et amplificateur - UDA-1 (568.21 kb)
Récepteur et amplificateur - UDA-1 (569.03 kb)
Récepteur et amplificateur - UDA-1 (566.34 kb)
Récepteur et amplificateur - UDA-1 (570.84 kb)
Facilité d'utilisation
Please note that the use of this accessory with iPod or iPhone may affect wireless performance. Made for iPod/iPhone models The compatible iPod/iPhone models are as follows. Update your iPod/ iPhone with the latest software before using with the unit. USB works with: .iPhone iPhone 5/iPhone 4S/iPhone 4/iPhone 3GS/iPhone 3G .iPod touch iPod touch (5th generation)/iPod touch (4th generation)/ iPod touch (3rd generation)/iPod touch (2nd generation) continued 3GB .iPod iPod classic .iPod iPod classic Other trademarks and trade names are those of their respective owners. 4GB Precautions On safety Should any solid object or liquid fall into the cabinet, unplug the unit and have it checked by qualified personnel before operating it any further. On power sources .Before operating the unit, check that the operating voltage is identical with your local power supply. The operating voltage is indicated on the nameplate on the back of the unit. .The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. .If you are not going to use the unit for a long time, be sure to disconnect the unit from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. .The AC power cord (mains lead) must be changed only at a qualified service shop. On placement .Place the unit in a location with adequate ventilation to prevent heat buildup and prolong the life of the unit. .Do not place the unit near heat sources, or in a place subject to direct sunlight, excessive dust, or mechanical shock. .Do not place anything on top of the cabinet that might cause malfunctions. .Use caution when placing the unit on surfaces that have been specially treated (with wax, oil, polish, etc.) as staining or discoloration of the surface may result. On operation Before connecting other equipment, be sure to turn off and unplug the unit. On cleaning Clean the cabinet, panel, and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. 5GB Specifications Amplifier section Reference Power Output 23 W + 23 W (4 ohms, 1 kHz, THD 10%) Rated Power Output 20 W + 20 W (4 ohms, 1 kHz, THD 0.9%) Speaker impedance match 4 ohms - 16 ohms S/N ratio LINE IN: 100 dB (short-circuit input, 20 kHz LPF, A Network) USB IN: 100 dB (20 kHz LPF, A Network) Frequency response 10 Hz - 100 kHz (+0 dB, –3 dB) (4 ohms, LINE IN) Input section (digital) USB REAR (USB-B jack) USB 2.0 compatible Supported format PCM (Sampling frequency: 44.1 k/48 k/88.2 k/96 k/176.4 k/ 192 kHz, data bit length: 16/24/32 bits) DSD (2.8 M/5.6 MHz) USB FRONT (USB-A jack) USB 2.0 compatible Supported format PCM (Sampling frequency: 32 k/44.1 k/48 kHz, data bit length: 16 bits) COAXIAL jack Input impedance: 75 ohms Supported format PCM (Sampling frequency: 32 k/44.1 k/48 k/88.2 k/96 k/176.4 k/ 192 kHz, data bit length: 16/24 bits) OPTICAL jack Supported format PCM (Sampling frequency: 32 k/44.1 k/48 k/88.2 k/96 kHz, data bit length: 16/24 bits) 6GB Input section (analog) Input sensitivity: 500 mV Input impedance: 100 kilohms Output section LINE OUT Output voltage: 2 V Output impedance: 2.2 kilohms 2 Hz - 80 kHz (–3 dB) PHONES 17 mW + 17 mW (8 ohms, THD 1%) 55 mW + 55 mW (32 ohms, THD 1%) 170 mW + 170 mW (300 ohms, THD 1%) General and others Power requirements AC 220-240 V 50/60 Hz Power consumption On: 65 W During standby mode: 0.3 W Dimensions (approx.) (w/h/d) 225 mm . 74 mm . 262 mm including projecting parts and controls Mass (approx.) 4.0 kg Supplied accessories AC power cord (1) Remote control (RM-ANU182) (1) USB cable (1) Quick Start Guide (1) Reference Guide (this manual) (1) Design and specifications are subject to change without notice. .Standby power consumption: 0.3 W 77B ADVARSEL ADVARSEL l eller i et skab. Reducer risikoen for brand ved at undlade at d.kke den overste del af apparatet til med aviser, duge, gardiner osv. Uds.t ikke apparatet for aben ild (f.eks. t.ndte stearinlys). Forhindr brand eller elektrisk stod ved at undlade at uds.tte dette apparat for dryp eller sprojt, og lad v.re med at anbringe genstande, der indeholder v.sker, f.eks. vaser, pa apparatet. Enheden er stadig tilsluttet stromkilden, sa l.nge den er tilsluttet stikkontakten i v.ggen, selvom selve enheden er slukket. Da stromforsyningsstikket bruges til at koble enheden fra elnettet, skal den kobles til en stikkontakt, som det er nemt at fa adgang til. Hvis enheden ikke reagerer som forventet, skal du straks tage stikket ud af stikkontakten i v.ggen. Uds.t ikke batterier eller apparater, der har batterier installeret, for kraftig varme, som f.eks. solskin eller ild. Kraftigt lydtryk fra oreproptelefoner og hovedtelefoner kan forarsage tab af horelse. Kun til brug indendors....