Log:
Évaluations - 2, GPA: 3.5 ( )

Instructions Remington, Modèle Garden Wizard 109312-01

Fabricant : Remington
Taille : 1.66 mb
Nom Fichier : 3292b488-c88f-98d4-bd3f-fc176d4e7e67.pdf
Langue d'enseignement: enesfr
Aller à la télécharger



Facilité d'utilisation


Improper use of tiller can cause severe injury. Keep this manual for future reference. ® ® ELECTRIC TILLER SAFETY WARNINGS WARNING: When using electric gardening appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury. WARNING: This product contains chemicals known to the State of California to cause cancer or birth defects, or other reproductive harm. READ ALL INSTRUCTIONS BEFORE OPERATING TILLER 1. Do not operate tiller near underground electric cables, telephone lines, pipes, or hoses. If in doubt contact your utility company to locate underground services. You may also contact the National One Call referral number, 1-888258- 0808, for local contact information concerning underground utilities. 2. Watch what you are doing. Use common sense. Do not operate tiller when you are tired. 3. Only well-instructed adults should operate tiller. Never allow children to operate tiller. 4. Do not use the tiller for any job except that for which it is intended. 5. Use only electrical voltage noted on model plate of tiller. WARNING: To reduce the risk of electric shock, use only with an extension cord intended for outdoor use, such as an extension cord of cord type SW-A, SOW-A, STW-A, STOW-A, SJW-A, SJOW-A, SJTW-A, or SJTOW-A. 6. Extension Cord - Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized extension cord will cause a drop in line voltage resulting in loss of power and overheating. The table below shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord. To reduce the risk of disconnection of tiller cord from the extension cord during operation use the cord hitch and belt clip described in this manual. Volts Total Length of Cord in Feet 120 25 50 100 150 Ampere Rating AWG 10-12 16 16 14 12 7. Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit(s) for use with this tiller. Receptacles are available with built-in GFCI protection and may be used for additional measure of safety. 8. Avoid Dangerous Environments. Do not operate tiller • while under the influence of alcohol, medication, or drugs. • in rain or in damp or wet areas. • where highly flammable liquids or gases are present. • if tiller is damaged, or not fully and securely assembled. 9. Always wear eye protection which meets or exceeds the requirements of ANSI Z87.1. 10. Always use face or dust mask if operating tiller in dusty conditions. 11. Always dress properly. Wear the following clothing while using tiller: • Use of rubber gloves and substantial footwear is recommended. •Wear protective hair covering to contain long hair. •Avoid wearing loose clothing or jewelry that could get caught in the rotating tines. 12. Thoroughly inspect area where the tiller is to be used and remove all foreign objects. WHILE OPERATING TILLER 1. Stay alert. Use common sense while operating tiller. 2. Be aware of extension cord while operating tiller. Be careful not to trip over cord. Keep cord away from tines at all times. 3. Keep all children, animals, and bystanders away from tiller and extension cord. Keep the area of operation clear of all persons and pets. 4. Grip handlebar firmly with both hands. Never operate tiller with one hand. 5. Be aware that tiller may unexpectedly bounce upward or jump forward if the tines should strike extremely hard, packed soil, frozen ground, or buried obstacles such as large stones, roots, or stumps. 6. Do not over reach. Maintain proper footing and balance at all times. 7. Do not operate tiller on a slope that is too steep for safe operation. When on slopes, slow down and make sure you have good footing. 8. IMPORTANT: you can stop the tines by releasing the trigger lever. 9. Before starting tiller, make sure tines are not touching foreign objects. 10. Do not allow hands or any body part or clothing near the rotating tines. 11. Move tiller from one place to another • with tiller stopped and unplugged. • by rolling on attached wheel assembly in the down “transport” position. •by holding carrying handle. Never use handlebars, tines, tine shaft, or fender to carry tiller. 12. Do not abuse power cord. Never carry tiller by power cord or yank it to disconnect from receptacle. Keep power cord from heat, oil, and sharp edges. 13. Do not force tiller. It will do the job better and with less likelihood of a risk of injury at the rate for which it was designed. For more information, visit 2 OWNER’S MANUAL SAFETY WARNINGS Continued MAINTENANCE AND STORAGE OF TILLER 1. Unplug tiller from power source • when not in use. • before moving from one place to another. • before servicing. • before assembling or removing tines or other attachments. 2. Inspect tiller before and after each use. Check for any da...


Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories