Évaluations - 4, GPA: 3.8 ( )

Fabricant : Honda Power Equipment Taille : 1.09 mb Nom Fichier : Langue d'enseignement:

Operate the machine in an open area to get the “feel” of the machine and its controls. Starting and Stopping the Engine Before starting the engine check that all bolts are tight, and that the tiller is assembled properly. Review Safety suggestions and Operating Instructions for safe and proper use of the tiller. Pre Start 1. Check the spark plug for proper connection on the spark plug. 2. Fill the fuel tank with clean, fresh, regular gasoline from an approved container. 3. Check the oil for proper level. Refer to engine owner’s manual for correct grade and quantity and directions. 4. Make certain clutch lever is in disengaged position. Starting Procedure 1. Move throttle control lever to center position. 2. Manually open choke. Hold the handle with your left hand while pulling the starter rope with your right. Pull the rope out slowly until the engine reaches the start of the compression cycle (the rope will pull slightly harder at this point). Then allow the rope to retract fully. 3. Pull the rope with a continuous full arm stroke. Keep a firm grip on the starter handle and let the rope rewind slowly. Do not let the handle snap back against the starter. Figure 4 DANGER To avoid possible serious bodily injury, keep hands and feet away from tines and v-belt before and after starting engine. 12 5 4. Repeat steps Number 2 and 3 above until the engine starts. If the engine fails to start after 3 pulls on the rope, repeat Step 1 above as necessary. Close choke after engine has responded. 5. As the engine warms up, move the throttle lever to desired position. Alllow engine warm-up period before operating tiller. NOTE: A warm engine may start without choking. Do not use the choke if engine is hot. Stopping Engine 1. Move the throttle control to rear position. 2. Push stop switch at spark plug. 3. Disconnect the wire from the spark plug to prevent accidental starting of the machine while it is unattended. OPERATION OF THE CHAIN DRIVE TILLER DANGER 1. When the ground is hard (especially during spring and fall plowing), place wheels in up position by pulling To prevent personal injury, the chain drive spring loading pin and lifting wheels. Release pin. For must disengage immediately when clutch leweeding or cultivating, wheels may be left down if you ver is released. If it does not, stop the tiller, prefer. adjust belt and cable tension as described in Adjustments section of this manual. 2. Adjust the drag stake for comfortable operation. Never leave the tiller unattended with the This is done by depressing pin, and sliding the drag engine running. Children are attracted to a stake up or down. The drag stake should be set so that running tiller and could be injured if struck when it is firmly in the ground, and your hands are on by the rotating tines. the tiller handle, your arms hand comfortably with the elbows slightly bent. 3. Move throttle control to center position. Start the engine and allow it to warm up, then set the throttle at WARNING about half ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :