Log:
Évaluations - 2, GPA: 5 ( )

Instructions Dell, Modèle EMP

Fabricant : Dell
Taille : 16.84 mb
Nom Fichier :
Langue d'enseignement: ruplhrenesfrdeslhuptskdacs
Aller à la télécharger



Facilité d'utilisation


CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. CAUTION: The memory modules can become extremely hot during operation. Allow the modules sufficient time to cool before handling. NOTICE: To help avoid possible damage to the system board, wait 5 seconds after turning off the system before removing a component from the system board or disconnecting a peripheral device. 1 Turn off the system and any devices. 2 Ground yourself by touching an unpainted metal surface on the chassis before touching anything inside the system. 3 While you work, periodically touch an unpainted metal surface on the chassis to dissipate any static electricity that might harm internal components. 4 Disconnect your system and devices from their power sources. To reduce the potential of personal injury or shock, disconnect any telecommunication lines from the system. In addition, take note of these safety guidelines when appropriate: • When you disconnect a cable, pull on its connector or on its strain-relief loop, not on the cable itself. Some cables have a connector with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before disconnecting the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, make sure that both connectors are correctly oriented and aligned. • Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a component such as a microprocessor chip by its edges, not by its pins. SAFETY: Protecting Against Electrostatic Discharge Electrostatic discharge (ESD) events can harm electronic components inside your computer. Under certain conditions, ESD may build up on your body or an object, such as a peripheral, and then discharge into another object, such as your computer. To prevent ESD damage, you should discharge static electricity from your body before you interact with any of your computer’s internal electronic components, such as a memory module. You can protect against ESD by touching a metal grounded object (such as an unpainted metal surface on your computer’s I/O panel) before you interact with anything electronic. When connecting a peripheral (including handheld digital assistants) to your computer, you should always ground both yourself and the peripheral before connecting it to the computer. In addition, as you work inside the computer, periodically touch an I/O connector to remove any static charge your body may have accumulated. You can also take the following steps to prevent damage from electrostatic discharge: • When unpacking a static-sensitive component from its shipping carton, do not remove the component from the antistatic packing material until you are ready to install the component. Just before unwrapping the antistatic package, be sure to disch...

Ce manuel est également adapté pour les modèles :
Plomberie - AMP01 (16.84 mb)
Plomberie - AND SVUA (16.84 mb)
Plomberie - BMX (16.84 mb)
Plomberie - ECM (16.84 mb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories