You can use wall-mounting screws (not provided) to hang the switch in an open space on a wall. Make sure that the selected location is: • Not in direct sunlight or near a heater or heating vent. Modem • Not cluttered or crowded. There must be at least 2 inches (5 cm) of air space on all sides of the switch. • Well ventilated (especially if it is in a closet). You need a Category 3 (10 Mbps) or Category 5 (100 Mbps) Ethernet cable with RJ-45 connectors for each device you connect to the switch. Each Ethernet cable must be less than 4. Check the LEDs: 328 feet (100 meters). Power Install the Switch and Connect Devices 1. Place the switch on a flat surface or hook it onto the screws. 2. For each device, insert one end of an Ethernet cable into a • Verify that the Power LED is lit. port on the switch and the other end into the network port • For each jack that is connected to a powered device, on the device. check that the Link LED is lit and it flashes when activity 3. Connect the power adapter cord into the back of the switch occurs. and then plug the adapter into a power source (such as a Note: If any LED does not operate as indicated, go to the wall socket or power strip). Troubleshooting section. Power FS208 8-Port Firewall Ethernet switch FS205_FS208_IG small.fm Page 2 Tuesday, August 7, 2012 9:57 AM Technical Specifications Standards compatibility IEEE 802.3u 100BASE-TX Fast Ethernet IEEE 802.3i 10BASE-T Ethernet IEEE 802.3x Flow Control Network interface RJ-45 connector for 10BASE-T and 100BASE-TX Power 12W max. and 12V @ 1.0A DC input Power consumption (max.) FS205: 2.3W FS208: 2.7W Dimensions FS205: 110 x 71 x 26 mm (4.33 x 2.79 x 1.02 in.) FS208: 152 x 93 x 26 mm (5.98 x 3.66 x 1.02 in.) Weight FS205: 100 g (0.22 lbs) FS208: 130 g (0.286 lbs) Operating temperature 0° to 40° C (32° to 104° F) Operating humidity 90% maximum relative humidity, non-condensing Safety agency approvals CE mark, CB for the power adapter July 2012 Performance Specifications Frame filter rate 14,880 frames/sec max. for 10M port 148,800 frames/sec max. for 100M port Frame forward rate 14,880 frames/sec max. for 10M port 148,800 frames/sec max. for 100M port Network latency (using 64 100 Mbps:12 .s byte packets) 10 Mbps: 85 .s Address database size FS205: 2K MAC addresses FS208: 1K MAC addresses Queue buffer FS205: 384 KB embedded FS208: 768 KB embedded Troubleshooting The Power LED is not lit. • Make sure that the power cord is correctly connected. • Make sure that the power adapter is connected to a functioning power outlet or power strip. • Make sure you that are using the NETGEAR power adapter supplied with your switch. The Port LED for a device is off or stays on continuously. • Make sure that the cable connectors are securely plugged in at the switch and the device. • Make sure that the connected device is turned on. • If the Ethernet cable is connected to a NIC or other Ethernet adapter, make sure that the card or adapter is installed correctly and is working. ...

Ce manuel est également adapté pour les modèles :
Matériel de réseau - FS208 (226.67 kb)