Évaluations - 2, GPA: 4
(
)
)
|
Facilité d'utilisation
The package contains three sets of crimping dies. Each set of dies is designed for different connectors and their marking and application are shown in the following table. Die Marking Cavity Marking Application BC/ST .151 ST* (BAYONET), FC-1, BICONIC .178 TECS (SMA) 200/230 .213 PROTECTIVE COVER-8500 SC sPLICE SC and FC-3 .120 2.4mm CABLE CRIMP RING .137 3.0mm CABLE CRIMP RING .190 KEVLAR CRIMP AREA PPST ST ( PUSH PULL) .120 2.4mm CABLE CRIMP RING .137 3.0mm CABLE CRIMP RING .226 KEVLAR CRIMP AREA Installing the Dies in the Base Tool 1. Select the appropriate set of dies as identified in the table above. 2. Squeeze and release the handles of the crimp tool to open the jaws. 3. Insert the dies into the jaws with the deep half of the round dies into the movable jaw. Match the shallow half with corresponding cavities before inserting. 4. Retain the dies loosely with the thumb screws. 5. Close the jaws completely to exactly align the dies. Then secure them in place by tightening the thumb screws. 6. Follow mounting procedures outlined in the appropriate connector instruction manual. See listing at right. "ST*" is a trademark of AT&T Movable Thumb Screws Lift For Emergency Jaw (To secure dies) Ratchet Release CONNECTOR INSTRUCTION STYLE MANUAL NUMBER BICONIC**-78-6900-1917-5 SC/FC-3 - 34-7033-9144-0 ST* (BAYONET) and FC-1- 78-6900-1806-0 ST* (PUSH PULL) EPOXY ADHESIVE-78-8073-7530-4 ST* (PUSH PULL) HOT MELT ADHESIVE 78-8073-7529-6 ST* (BAYONET) HOT MELT ADHESIVE— 80-6106-2571-9 (Crimp Tool Not TECS (SMA) -Req4-7©3)1-4262-9 ** To prevent deformation of the Biconic housing, insert the connector from the nonrecessed side of the die. Note: The crimp rings for the ST Push Pull Connector have been improved over the ones used in the manuals listed above. To obtain a new die to fit previous ST Push Pull crimp tools, please call customer service. Important Notice All statements, technical information and recommendations related to the Seller's products are based on information believed to be reliable, but the accuracy or completeness thereof is not guaranteed. Before utilizing the product, the user should determine the suitability of the product for its intended use. The user assumes all risks and liability whatsoever in connection with such use. Any statements or recommendations of the Seller which are not contained in the Seller's current publications shall have no force or effect unless contained in an agreement signed by an authorized officer of the Seller. The statements contained herein are made in lieu of all warranties, express or implied, including but not limited to the implied warranties of merchantability and fitness for a particular purpose which warranties are hereby expressly disclaimed. SELLER SHALL NOT BE LIABLE TO THE USER OR ANY OTHER PERSON UNDER ANY LEGAL THEORY, INCLUDING BUT NOT LIMITED TO NEGLIGENCE OR STRICT LIABILITY, FOR ANY INJURY OR FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES SUSTAINED OR INCURRED BY REASON OF THE USE OF ANY OF THE SELLER'S PRODUCTS THAT WERE DEFECTIVE. 3M Telecom Systems 6801 River Place Blvd. 34-7034-5908-0 Austin, TX 78726-9000 Printed in USA 800/426-8688 © 3M 1993...