When the port is at the end of a segment, using a T connector with a terminating plug may cause interference with adjacent ports. 3Com recommends terminating ports with the ITT Pomona Y connector, Model 4896, with a terminating plug on the end, or the ITT Pomona Feed-Thru Terminator, Model 4119-50. When the port is in the middle of a segment, the Y connector may be necessary. Prior to installing the unterminated 10BASE-2 (BNC) module, LANplex system software revision 7.0.0 or later and LANplex d

ACCUSYS, INC. 5F, 38 TAIYUAN ST, JHUBEI, HSINCHU, TAIWAN, R.O.C. TITLE EXPERAID COMMAND LINE INTERFACE USER GUIDE PROJECT “DESKTOP RAID” DOCUMENT STATUS OFFICIAL RELEASE REV. G–05-NOV-2007 PAGE 20 OF 27 3.3.4.3 Command Name Command Description RebuildParity Use this command to rebuild parity of an array which contains parity. i.e. RAID 5 or RAID 6. Parameter 1 Parameter Description Array No.: > Array No.: Specify an array number to rebuild parity. Status setting: Start or stop the pa

2 Connect one end of the ADSL cable (RJ-11) to the connector on the rear of the HomeConnect ADSL Modem Ethernet marked ADSL and connect the other end to your ADSL wall jack (or Network Interface Device (NID)). CAUTION: The DSL line outlet uses the same type connector as a normal voice telephone line. Take care not to accidentally connect your HomeConnect ADSL Modem Ethernet to a telephone outlet, and never connect a phone to your HomeConnect ADSL Modem Ethernet. 3 Select the DIP switch mode (thi

2 Double-click the Control Panel icon. 3 Double-click the Network icon. 4 Select the 3Com Megahertz LAN PC Card. 5 Click Properties. 6 Click Advanced. ¦ For network driver optimization, click DOS Client or Windows or OS/2 client or server. ¦ For full duplex, click enable to use full duplex and disable if you do not want to use full duplex. Only use full duplex if you have a full duplex network. ¦ For NDIS driver version, click auto-select, NDIS 3, NDIS 4, or NDIS 5. NDIS 5 only works with Window

You can gather information about the status of the module and its packet activity using LEDs on the front of the Switch and on the module itself. The module requires management software version 2.42 or later to be installed on the Switch. For instructions on LED Color Indicates upgrading management software, refer to the documentation supplied with your Switch. The module conforms to the full duplex implementation of the Gigabit Ethernet standard IEEE 802.3ab. The module supports a 100 m cable s

These GEN Interface Modules serve as a 2-Gigabit data channel between the Gigabit Ethernet Switch Fabric Module and other IEEE 802.3z-compliant Gigabit Ethernet devices. The GEN Interface Modules support the following key features: ¦ Two front panel IEEE 802.3z–compliant Gigabit Ethernet fiber-optic ports that connect to a dedicated, non-blocking, redundant Gigabit Ethernet backplane channel ¦ 850nm multimode support on the 1000BASE-SX GEN Interface Module ¦ 1300nm single-mode support on the 100

Follow the steps below to select an array to verify, rebuild or condition. 1. Select the Array to verify, rebuild or condition. 2. Click the radio button to Rebuild parity data, Verify parity data or perform Background drive member conditioning. If choosing Background drive member conditioning choose the priority between Low, Med or High. 3. Click OK to start the operation. Unlock drives Locked drives are drives that for one reason or another have stopped being recognized by the controller. Foll