DAC960PG and DAC960PJ Installation Regulatory Information Declaration of Conformity Per 89\336\EEC Responsible Party Name: Mylex Corporation Address: 34551 Ardenwood Boulevard Fremont, CA 94555-3607 USA hereby declares that the product Trade Name: High Performance Caching RAID Controller Model Number: DAC960PG/PJ conforms to the following specifications Standards: EN 50081-1:1992, EMI EN 55022 Class B (Radiated), Class B (Conducted) EN 50082-1:1992, Immunity EN 61000-4-2:1995 Electrostatic Disch

The default segment size for Mylex RAID controllers is 8K. Caching Allows data to be stored in a pre-designated area of a disk or RAM. Caching speeds up the operation of RAID systems, disk drives, computers and servers, or other peripheral devices. CD-ROM Compact Disk-Read Only Memory, a removable read-only storage device, similar to an audio compact laser disk, holding up to 640MB of data. Channel Any path used for the transfer of data and control of information between storage devices and a st

For example, a system using a five-disk-drive RAID set can add another disk drive to create a six-disk-drive RAID set. The M.O.R.E. operation can be performed on all RAID levels except JBOD. Mylex’s Global Array Manager (GAM) supports two M.O.R.E. features: Expand Capacity allows logical drive expansion for FFx external controllers only. Expand Array allows array expansion for both PCI and FFx external controllers. During the RAID set expansion process, which includes re-striping data from the o

All contents of this manual are copyrighted by Mylex Corporation. The information contained herein is the exclusive property of Mylex Corporation and shall not be copied, transferred, photocopied, translated on paper, film, electronic media, or computer-readable form; or otherwise reproduced in any way, without the express written permission of Mylex Corporation. Greetings This manual describes the Mylex PCI Disk Array Controllers. Requests for technical information about this and other Mylex Co

5 Troubleshooting Appendix A: Acer Altos R520 rack installation guide This appendix shows you how to set up the Acer Altos R520 server in a rack mount configuration. Setting up the system rack Important! Observe the electrostatic discharge (ESD) precautions indicated on page 39 when perfoming the following procedures. Do not attempt the procedures described in the following sections unless you are a qualified technician. Equipment rack precautions Follow the rack manufacturer's safety and instal

1 Section Three AT Command Set .................. 4 Section Four S Register Summary ........... 12 Section Five Result Codes ......................... 13 Section Six Troubleshooting ................... 14 Section Seven Specifications ....................... 16 Section Eight Support And Service ........... 16 Section Nine FCC, DOC, Copyright And Other Notices ....................... 17 Part #49.AA808.001 ACER 14.4 TAD-SP 1.xx Section One - Introduction This 14.4 Kbps FAX/Voice/Data Modem is speci

SCSI transfers eight or 16 bits in parallel and can operate in either asynchronous or synchronous modes. The synchronous transfer rate is up to 320 Mbytes/s (for Ultra320 SCSI). SCSI connections normally use single-ended drivers, as opposed to differential drivers. SCSI Channel MegaRAID controls the disk drives through SCSI-2 buses (channels) over which the system transfers data in either Fast and Wide or Ultra SCSI mode. Each adapter can control up to three SCSI channels. Internal and external

The information contained in this document is subject to change without notice. Copyright © Copyright 1997-1998, Acer Netxus Inc. All Rights Reserved. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic, or other means, in any form, without the prior written permission of the manufacturer. Trademarks All trademarks and registered trademarks are the property of their respective owner

FCC Class B Radio Frequency Interference Statement The manufacturer is not responsible for any radio or television interference caused by unauthorized modification of this device or the substitution or attachment of connecting cables and equipment other than specified. The correction of interference caused by such unauthorized modification, substitution or attachment will be the responsibility of the user. Built-in antennas, whether installed indoors or out, should be installed only by experienc

Windows 95/98 and Windows 2000 are trademarks of Microsoft Corp. Pentium is trademark of Intel. All copyright is reserved. 1 Table of Contents 1. Welcome……………………………………………………………4 1.1 Kit Contents................................................................................ 5 1.2 Main Feature of WLAN USB Adapter.......................................7 1.3 Wireless Networking Scenarios.................................................. 9 1.4 Advantages for Using Wireless Network...................