Log:
Évaluations - 0, GPA: 0 ( )

Instructions Brother, Modèle CS9100

Fabricant : Brother
Taille : 1.58 mb
Nom Fichier :
Langue d'enseignement: en
Aller à la télécharger



Facilité d'utilisation


REPLACING THE PRESSER FOOT REPLACING THE PRESSER FOOT CAUTION . Always turn off the power before you change the presser foot. If you leave the power on and step on the controller, the machine will start and you may be injured. . Always use the correct presser foot for the stitch pattern you have chosen. If you use the wrong presser foot, the needle may strike the presser foot and bend or break, and may cause injury. . Only use presser feet that have been designed to be used with this machine. Using other any presser feet may cause an accident or injury. 1 Replacing the presser foot Replace the presser foot as described below. Raise the needle by turning the handwheel a toward you (counterclockwise) so that the mark on the wheel points up. (With models equipped with (needle position button), raise the needle by pressing once or twice.) or a Mark b Needle position button b If the sewing machine has been turned on, turn it off. CAUTION . Before replacing the presser foot, be sure to turn off the sewing machine, otherwise injuries may occur if the foot controller or the start/stop button is accidentally pressed and the machine starts sewing. Raise the presser foot lever. c a Presser foot lever d Press the black button at the back of the presser foot holder to release the presser foot. a Black button b Presser foot holder Place a different presser foot below the holder e so that the presser foot pin is aligned with the shank in the holder. Position the presser foot so the letter indicating the presser foot type (J, A, etc.) is positioned to be read. a Presser foot holder b Shank c Pin Note . The presser foot to be used with each stitch appears in the LCD. To select a stitch, refer to “Selecting a stitch” (page 28). 25 KNOWING YOUR SEWING MACHINE KNOWING YOUR SEWING MACHINE f Slowly lower the presser foot lever so that the presser foot pin snaps into the shank in the presser foot holder. a Presser foot lever • The presser foot is attached. Raise the presser foot lever to check that the g presser foot is securely attached. Removing the presser foot holder Remove the presser foot holder when cleaning the sewing machine or when installing a presser foot that does not use the presser foot holder, such as the quilting foot. Use the screwdriver to remove the presser foot holder. ¦ Removing the presser foot holder Remove the presser foot. a • For details, refer to “Replacing the presser foot” (page 25). b Use the screwdriver to loosen the presser foot holder screw. ¦ Attaching the presser foot holder Align the presser foot holder with the lower- a left side of the presser bar. a Presser foot holder b Presser bar b Hold the presser foot holder in place with your right hand, and then tighten the screw using the screwdriver in your left hand. a Screwdriver b Presser foot holder c Presser foot holder screw Note . If the presser foot holder is not correctly ...


Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories