Évaluations - 3, GPA: 4
(
)
)
|
Facilité d'utilisation
Secure vacuum tube by turning the knob clockwise until tight. Hooks Knob D When converting back to the blower feature, make sure latch on the vacuum inlet cover is securely fastened. USING YOUR UNIT WARNING: You MUST make sure the tubes are secure before using the unit. OPERATING POSITION Blower Eye Protection Vacuum OPERATING TIPS S While vacuuming or blowing debris, hold the unit with the muffler side facing away from your body and clothes (see illustration above). S To reduce the risk of hearing loss associated with sound level(s), hearing protection is required. S To reduce the risk of injury associated with contacting rotating parts, stop the engine before installing or removing attachments. Do not operate without guard(s) in place. S Operate power equipment only at reasonable hours--not early in the morning or late at night when peoplemight be disturbed. Comply with times listed in local ordinances. Usual recommendations are 9:00 a.m. to 5:00 p.m., Monday though Saturday. S To reduce noise levels, limit the number of pieces of equipment used at any one time. S To reduce noise levels, operate power blowers at the lowest possible throttle speed to do the job. S Use rakes and brooms to loosen debris before blowing. S In dusty conditions, slightly dampen surfaces or use a mister attachment when water is available. S Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens. S Watch out for children, pets, open windows, or freshly washed cars. Blow debris away safely. S Use the full blower nozzle extension so the air stream can work close to the ground. S After using blowers and other equipment, CLEAN UP! Dispose of debris in trash receptacles. FUELING WARNING: Remove fuel cap slowly when refueling. This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality 2-cycle air-cooled engine oil. We recommend Poulan/Weed Eater brand oil. Mix gasoline and oil at a ratio of 40:1 (A 40:1 ratio is obtained by mixing 3.2 ounces of oil with 1 gallon of unleaded gasoline). When mixing fuel, follow the instructions printed on the container. Always read and follow safety rules under HANDLE FUEL WITH CAUTION in the safety rules section. STARTING TO STOP THE ENGINE D To stop the engine, press and hold the switch in the STOP position until engine comes to a complete stop. BEFORE STARTING THE ENGINE D Fuel engine. Move at least 10 feet (3 meters) away from the fueling site. D Hold the unit in the starting position as shown. Make sure the blower end is directed away from people, animals, glass, and solid objects. --5 BlowerVacuumSTARTINGPOSITION WARNING: When starting engine, hold the unit as illustrated. Do not set unit on any surface except a clean, hard area when starting engine or while engine is running. Debris such as gravel, sand, dust, grass, etc. could be picked up by the air intake and thrown out through the discharge opening, damaging the unit or property, or causing serious injury to bystanders or the operator. STARTING A COLD ENGINE OR WARM ENGINE THAT HAS RUN OUT OF FUEL S Move throttle lever to the position. S Move choke lever to FULL CHOKE. S Slowly press the primer bulb 12 times. Throttle Lever Primer Button Choke Lever Switch S Pull starter rope sharply until engine attempts to run, but no more than 5 pulls (below 30_ F, 8 pulls). NOTE: If engine attempts to start before the 5th pull, go to next step immediately. S Move the choke lever to HALF CHOKE. S Pull the starter rope sharply until the engine runs, but no more than 5 pulls (below 30_ F, 10 pulls). Run engine for 5 seconds, then move choke lever to OFF CHOKE. S Allow the unit to run for 30 more seconds at OFF CHOKE before moving the throttle lever to position. If engine has not started after 5 pulls (at HALF CHOKE), repeat STARTING A COLD ENGINE procedure. If engine still does not start, proceed to STARTING A FLOODED ENGINE. STARTING A WARM ENGINE THAT HAS NOT RUN OUT OF FUEL S Move throttle lever to the position. S Pull starter rope sharply until engine runs, but no more than 5 pulls. NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded. - -- -- 6 -- STARTING A FLOODED ENGINE S Move the choke lever to OFF CHOKE. S Move throttle lever to the position. S Pull rope to clear engine of excess fuel. This could require pulling the starter rope many times. If unit still doesn’t start, call 1-800-554-6723. SERVICE We recommend all service and adjustments not listed in this manual be performed by an authorized service dealer. CARBURETOR ADJUSTMENTS Your carburetor is equipped with limiter caps. Carburetor adjustment is a complicated task. We recommend that you take your unit to an authorized service dealer. Damage may occur if you turn the needles beyond the limiter stops. IGNITION TIMING Ignition timing is fixed, non-adjustable....