Évaluations - 3, GPA: 3.7
(
)
)
|
Facilité d'utilisation
Place cap centrally on the top of crown (enamel side up). Move sideways and front to back to check the cap is properly fitted. 3. Check for ignition. If a burner will not light Do not attempt to remove any of the control then you need to check the crown and cap knobs from the appliance as this may cause positions. damage and is a safety hazard. Pan support Cap Hole Crown Location peg Pan support Cap Hole Crown Location peg Electrode Slots Body Cleaning the grill and oven furniture All removable parts, except the grill pan handle can be washed in the dishwasher. The grill pan, grill pan grid and oven shelves may be cleaned using a soap impregnated steel wool pad. Soaking first in hot soapy water will make cleaning easier. Cleaning the grill Do not clean the grill burner itself. Cleaning the grill may cause the holes in the burner to become blocked preventing it from operating correctly. Due to the nature of stainless steel the grill burner may tarnish through use over a period of time. This is quite normal and is not a fault on the appliance. Clean the area around the grill frequently using hot soapy water. Cleaning inside the grill and oven compartments • The sides and back of the main oven compartments are coated with a special Stay-clean coating. They should not be cleaned manually. • The vitreous enamel main oven base and grill/top oven compartment can be cleaned using normal oven cleaners with care. Ensure that the manufacturers instructions are followed and that all parts are well rinsed afterwards. . Aerosol cleaners must not come into contact with elements, the door seal, or any painted finishes as this may cause damage. . Aerosol cleaners must not be used on Stay- clean surfaces. • To carry out the cleaning cycle, remove the oven shelves and set the oven to gas mark 6. • It is a good idea to run the oven for an hour or two per week to ensure continued good performance from the Stay-clean finish. • Slight discolouration and polishing of the Stay- clean surfaces may occur in time. This does not affect the Stay-clean properties in any way. • Use minimal, if any, extra oil or fat when roasting meat, potatoes only require brushing with fat before cooking. Extra fat in the oven during roasting will increase splashing and staining of the cavity. • It is not necessary to add water to a meat tin when roasting. The water and the fat juices from the joint create excessive splattering during cooking – even at normal temperatures, as well as causing condensation. • Covering joints during cooking will also prevent splashing onto the interior surfaces. Removing the covering for the last 20-30 minutes will allow extra browning if required. Some large joints and turkeys especially benefit by this method of cooking, allowing the joint to cook through before the outside is over-browned. Cleaning the door(s) . To prevent damaging or weakening the door glass panels avoid the use of the following: • Household detergents and bleaches • Soap impregnated pads unsuitable for non-stick saucepans. • Abrasive cleaning pads, scourers and steel wool pads. • Chemical oven pads or aerosols. • Rust removers. • Bath/Sink stain removers. Cleaning between the outer and inner door glass . The inner door glass is removable for cleaning. . Please note that the door glass on your product may differ in type and shape from that shown in the diagrams. To remove the inner glass Open the oven door to gain access to the top of the oven door. Top Oven: • Carefully push the trim towards the oven and lift off. • Hold the door glass securely in place with one hand before sliding the glass out with the other hand. Main Oven: • Carefully push the trim towards the oven. • Hold the door glass securely in place with one hand before sliding the glass out with the other hand. . If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local service force centre who will be pleased to advise further. To replace the inner glass To ensure the glass is properly located the text should be facing towards you at the top edge of the door and facing into the cavity. Holding the glass with both hands, gently slide the glass into the side trims of the oven door. Always ensure that the glass is returned to the same side trim it was removed from. To replace the trim, line up the clips on the underside of the trim with the connectors at the top of the door. Carefully slide the trim towards the door. Ensure the trim is securely in place before closing the oven door. . Do not attempt to use the oven without the glass being in place. To clean the inner glass door panels Clean the inner glass door panels using hot soapy water, hob cleaner may also be used. Do not use hob cleaner on the stainless steel or painted surfaces. Ensure that all parts are well rinsed and thoroughly dried before attempting to replace the glass. Replacing an oven light bulb • ...