Évaluations - , GPA: ( )

Instructions Briggs & Stratton, Modèle 1687227

Fabricant : Briggs & Stratton
Taille : 153.41 kb
Nom Fichier : 408de330-05c8-c774-2985-b122c75f6300.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

1687227 & 1687228 Instructions For 2004 Simplicity 860EI Intermediate Snowthrowers W 1694433, 1694434 Kit Contents: Ref Part No. Qty. Description 1 1721684 1 GEAR CASE, RH 2 7090052 6 WASHER, 1/4” SPLIT LOCK 3 7092129 12 WASHER, FLAT, .268 x .591 4 7091576 6 NUT, HEX, 1/4-20 5 7092125 6 SCREW, HEX, 1/4-20 x 7/8 6 1721676 1 GASKET, GEAR CASE 7 1721685 1 GEAR CASE, LH 8 960625 1 FITTING - PIPE PLUG 4 Figure 1. Contents This kit is to service intermediate snowthrowers. INSTALLATION Disassemble Housing rik WARNING- Before beginning any service work turn off the ignition, and disconnect the spark plug wire(s). 1. Remove the washers and retaining rings (D, Figure 2) from both ends of the auger shaft. Remove the bearings (C). 2. Remove the hardware securing both side covers (A), and remove the side covers. Figure 2. Disassemble Housing A. Side Cover B. Housing C. Bearing D. Washers & Retaining Ring 1 Installation Instructions Gear Case Kit Remove Auger Assembly 1. Remove the impeller set screw (D, Figure 3) and drive pulley set screws (B). 2. Spray the impeller and pulley hubs with penetrating oil to help with disassembly. 3. Remove the pulley (C). 4. Remove the key (A). NOTE: Do not pry on the pulley. If necessary, separate the front housing from the rear drive section of the snowthrower and drive the rear auger shaft out of the pulley (C) with a punch. 5. Remove the impeller (E) from the rear auger shaft. Assemble New Gear Box & Impeller Assembly 1. Reassemble the auger gearbox assembly, impeller (E, Figure 3), key (A), and pulley (C). Torque the three set screws (B, D) to 9-11 ft. lbs. 2 Gear Case Kit Installation Instructions Assemble Housing 1. Install the side covers (A, Figure 4) and secure with the original hardware. 2. Reinstall the bearings (C), washers, and retaining rings (D) in both side covers. Figure 4. Assemble Housing A. Side Cover B. Housing C. Bearing D. Washers & Retaining Ring Fill Auger Gear Case Oil 1. Remove the fill plug (Figure 5). Fill the gear box with The Dealer Line Winter Weight Worm Gear Oil until the oil level reaches the bottom of the fill hole. Figure 5. Checking Auger Gear Case Lubrication 3 Installation Instructions NOTES Gear Case Kit SimpHnity MANUFACTURING, INC. 500 N Spring Street / PO Box 997 Port Washington, WI 53074-0997 USA Form No. 1732778-01 Rev. 12/2006 TP 200-4412-01-SK-SN Briggs & Stratton Yard Power Products Group Copyright © 2006 Briggs & Stratton Corporation Milwaukee, WI USA. All Rights Reserved 4...