10.Always keep a firm hold on and maintain control of the cutting tool. 11.If you are uncertain about the optimal speed, it is better to start with the slowest RPM and increase your speed as your comfort with the tool and the work piece increases. 12.Never force the tool or attachment to do the work of a larger industrial tool. It is designed to do the job better and more safely at the rate for which it was intended. REMOVING THE SPUR AND CUP CENTERS 1. Insert a pin into the Spindle (#28) hole a

4740 lbs. Length/Width/Height..................................................................................................................... 102 x 38-1/4 x 51 in. Foot Print (Length/Width)........................................................................................................................... 102 x 32 in. Shipping Dimensions: Type............................................................................................................................................

See the latest Grizzly Catalog or visit our web site at for price and ordering information. Most importantly, we stand behind our tools. If you have any service questions or parts requests, please call or write us at the location listed below. Grizzly Industrial, Inc. 1203 Lycoming Mall Circle Muncy, PA 17756 Phone: (570) 546-9663 Fax: (800) 438-5901 e-Mail: support@grizzly.com Site: Disconnect power to your lathe before beginning installation of the Model G8143 Collet Closer. To begin assembly,

REVISED FEBRUARY, 1999. PRINTED IN U.S.A. Table Of Contents PAGE 1. INTRODUCTION ........................................................................................................2 SAFETY RULES FOR ALL TOOLS ........................................................................3 UNPACKING............................................................................................................4 PIECE INVENTORY .............................................................................

#ts10612 printed in ChinA ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

See Figure 27. 2. Open the sliding fingers by turning the knurled screws until they fit around the workpiece. Secure the steady rest in position. 3. Tighten the knurled screws so that the fingers are snug, but not tight against the workpiece. Tighten the setscrews and the lock nuts. 4. Lubricate the brass points with machine oil. The Follow Rest is setup in the same manner except that the place of the third finger is taken up by the tool bit. The follow rest prevents long, small diameter pieces

3. slightly loosen backlash setting (page 63). 4. lubricate bedways and handles. Bad surface finish. 1. Wrong rpM or feed rate. 2. dull tooling or poor tool selection. 3. too much play in gibs. 4. tool too high. 1. Adjust for appropriate rpM and feed rate. 2. sharpen tooling or select a better tool for the intended operation. 3. tighten gibs (page 61). 4. lower the tool position. inaccurate turning results from one end of the workpiece to the other. 1. headstock and tailstock are not properly al

Be certain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI). We recommend you keep a copy of our current catalog for complete information regarding Grizzly's warranty and return policy. If you need additional technical information relating to this machine, or if you need general assistance or replacement parts, please contact the Service Department listed in Section 3: Introduction. Additional information sources are necessary to real

-16 G0456 Variable Speed Wood Lathe Adjusting Tailstock The tailstock is equipped with a cam-action clamping system to secure it to the lathe bed. When the lever is tightened, a locking plate lifts up and secures the tool rest to the bed. To position the tailstock along the bed: 1. Loosen the quick release and move the tailstock to the desired position (Figure 12). 2. Tighten the quick release. —If the quick release will not lock the tailstock down onto the bed (either too loose or too tight), l