Évaluations - 4, GPA: 4.5
(
)
)
|
Photos et spécifications Zanussi FE 1014 N |
Facilité d'utilisation
The data refers to the highest temperature provided for each programme. For cotton, it refers to a wash load of 4 kg. 19 ENGLISH Maintenance 1. Door seal Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold. 2. Bodywork Clean the outside of the machine with warm water and a neutral, non-abrasive household detergent. Rinse with clean water and dry with a soft cloth. Important: do not use methylated spirits, solvents or similar products to clean the bodywork. 3. Detergent dispenser drawer After a while, detergents and fabric softeners leave deposits in the drawer. Clean the drawer from time to time by rinsing it under a running tap. To remove the drawer from the machine, press the button in the rear left-hand corner. To facilitate cleaning, the top part of the additive compartments can be removed. Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the drawer after cleaning. 4. Drain filter The drain filter collects threads and small objects inadvertently left in the laundry. Check regularly that the filter is clean. Open the filter door. Place a container under the filter to catch any spillage. Unscrew the filter and remove it. Clean the filter under a running tap, then refit it, screwing it fully in. 20 5. Water inlet filter If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked. Turn off the water tap. Unscrew the hose from the tap. Clean the filter with a stiff brush. Screw the hose back onto the tap. 6. Emergency emptying out If the water is not discharged (outlet pump is blocked, filter or drain pipe are clogged), proceed as follows to empty out the machine: • pull out the plug from the power socket; • close the water tap; • if necessary, wait until the water has cooled down; • place a bowl on the floor; • put the drain hose end into the bowl and let the water come out. Should it not be possible to have access to the drain hose because, for example, the appliance is built in the kitchen furniture, slightly loosen the drain filter after placing a bowl on the floor, to let the water come out slowly. At the end screw the filter again. The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. • Turn off the water tap. • Unscrew the inlet hose. • Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl. Run the draining programme. To do this: • Switch the machine on • Select a washing programme • Press the RESET button three times • Press START/PAUSE button • Disconnect the appliance. • Screw the inlet hose and reposition the drain hose. • When you intend to start the machine up again, make sure that the room temperature is above 0°C. 21 ENGLISH Something not working? Problems which you can resolve yourself. During machine operation it is possible that the light —►!, the light of the START/PAUSE button ^ and one of the following lights start to flash: O: problem with the water supply (vvj: problem with water draining IHJ: door open Once the problem has been eliminated, press the START/PAUSE button ^ to restart the programme. If after all checks, the problem persists, contact your local Service Centre. Problem Possible cause • The machine does not start up: • The door is not firmly closed. • The machine is not plugged in or there is no power at the socket. • The main fuse has blown. • The START/PAUSE button has not been depressed. • The machine does not fill: • The water tap is closed. • The inlet hose is squashed or kinked. • The filter in the inlet hose is blocked. • The door is not properly closed. • The machine fills then empties immediately: • The end of the drain hose is too low. Refer to relevant paragraph in “water drainage” section. • The machine does not empty and/or does not spin: • The drain hose is squashed or kinked. • The RINSE HOLD option has been selected. • The drain filter is clogged. • There is water on the floor: • Too much detergent or unsuitable detergent (creates too much foam) has been used. • Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • The drain hose is damaged. • Unsatisfactory washing results: • Too little detergent or unsuitable detergent has been used. • Stubborn stains have not been treated prior to washing. • The correct temperature was not selected. • Excessive laundry load. • The machine vibrates or is noisy: • The transit bolts and packing have not been removed. • The support feet have not been adjusted. • The laundry is not evenly distributed in the drum. • Maybe there is very little laundry in the drum. • The door will not open: • The programme is still running, the drum is turning. • The door lock has not yet rele...