Évaluations - 9, GPA: 4.1
(
)
)
|
Facilité d'utilisation
Water inlet strainer Clean if water flows very slowly, or not at all. 1. Switch off the machine, turn off the water tap. 2. Take the inlet hose off. 3. Pull out the strainer in Aquasafe or the two strainers in Aquasafe+ (depending on the model) with universal or needle nosed pliers, clean with a small soft brush and fit back. 16 |«| Determining location and installation 1. Removing transport safety bolts at the rear of the machine The transport safety bolts must be removed before any operation of the machine. Bolt heads, marked “C”. “C”, should be turned in a anti clockwise direction until the bolt can be partially withdrawn. Remove transport safety bolts and rubber bushes by pulling outwards. (A up/down action and a small squirt of washing up liquid should ease removal.) Plastic plugs, supplied inside the protective bag and designated as “P”, should be placed in the safety bolt holes according to the direction shown. Attention! Please keep the safety bolts for future transportationand reinstate them before transporting your machine. Never transport your machine without the transport bolts in position. Never place your machine on a carpet. This prevents air circulation. The electrical components of the machine may overheat and may cause damage. 17 2. Feet adjustment In order for quiet and stable operation, the machine should be placed properly and leveled on its feet. Your machine comes with two adjustable feet. If the machine is unstable, loosen the plastic counternut and screw or unscrew the adjustable foot until the machine is leveled perfectly. After positioning, tighten the counternut for stability. 3. Water connections a) Water inlet hose Cold water supply For proper operation, the pressure of water should be between 1 and 10 atm. (1 atm corresponds to more than 8 liters per minute flow rate at fully open tap.) To prevent water leaks sealing washers are supplied with the water inlet hose inside the machine, place these on each of the hose ends and tighten both ends fully. In order to prevent any water leak damages, keep the water taps closed when not in use. Connect the cornered end of the hose to the machine water inlet. Connect the cold water using the hose with blue printing. 18 b) Water drain hose Water drain hose could be placed either at the side of the bath tub, or directly to the drain. The hose should not be bent. Water drain hose should be secured with the elbow so that it would not fall down on the ground. The hose should be placed between 40 and 100 cm. from the ground. 4. Electrical connection Connect the power cord to the appropirate electrical system which is being supported by the maximum voltage and current rating indicated on the rating plate placed inside the kick plate. Look! Page 1, Steps before operating Fullautomatic Washing Machine and safety precautions. Make sure that you have grounded power outlet. Helpful tips on stain removal The following stain removing tips are approximate and can only be used at the washable fabrics. Please consult the washing information of the fabric manufacturer. f Ratios are | I approximated. I Alcoholic baverages: Wipe the fabric first with water, then water-glycerine solution and rinse with vinegar-water solution. Shoe polish: Without harming the fabric, remove the stain carefully and grind it with detergent. If this doesn’t help, prepare a water to alcohol solution (2 to 1) and rub the fabric, then wash it with warm water. Tea and coffee: Pour hot water on to the stain and the fabric is white, pour some bleach and rinse it with water. Bubblegum: Harden the gum stain by putting an ice on it. Then scrape off the stain carefully. Chocolate and cocoa: Place the fabric into cold water for a period of time. Rub it with soap or detergent and wash it with the warmest water that the fabric can withold. If any grease stain leftover wipe it with oxygen water. Tomato paste: Scrape the hardened paste and leave the fabric for 40 minutes into cold water. Rub it with detergent and wash. Egg stain: If the stain is hardened scrape the stain and wipe it with wet sponge or a soft cloth. Rub it with detergent and wash with cold water. Grease stain: Scrape the stain and rub it with detergent. Then wash the fabric with warm water. Mustard: Use glycerin and rub the fabric with detergent. If lijiiii unsuccesful, wipe the stain with alcohol. (Colored and synthetic ■™ fabrics need 2 cups water and 1 cup alcohol solution.) Blood stain: Leave the fabric for30 minutes in the cold water. Use ammonia solution to remove the stain. (4 liters water-3 spoonful of ammonia.) Ice-cream, milk and cream: Place the fabric into cold water for a period of time. Rub it with soap or detergent and wash it with the warmest water that the fabric can withold. If any grease stain leftover wipe it with oxygen water. Mildew: Do not let mildew stains stay for long periods of time. Place the fabric into cold water for a period of time. Rub it with soap o...
Ce manuel est également adapté pour les modèles :Rondelles - WMD 55060 (6.03 mb)
Rondelles - WMD 55080 (6.03 mb)