Évaluations - 3, GPA: 3.7 ( )

Fabricant : Hotpoint Taille : 1.57 mb Nom Fichier : AWN-USB-11N2.pdf Langue d'enseignement:

This Wireless LAN utility as an Enrollee or external Registrar supports the configuration setup using PIN configuration method or PBC configuration setup using PIN configuration method or PBC configuration method through an internal or external Registrar. Pin Input Config (PIN): Start to add to Registrar using PIN configuration method. IF STA Registrar, remember that enter PIN Code read from you Enrollee before starting PIN. Push Button Config (PBC ): Start to add to AP using PBC configuration method. 4. Soft-AP Function Except becoming a wireless client of other wireless access points, this USB Wireless LAN utility can acts as a wireless service provider. You can switch the operating mode to “Access Point” mode to simulate the function of a real wireless access point by software, and all other computers and wireless devices can connect to your computer wirelessly, even share the internet connection you have. To the Wireless LAN USB Adapter to bridge your wired and wireless network, the following requirements must be met: 1. The Wireless LAN USB Adapter must be installed on a computer connected to the wired network. 2. Either configure network sharing (refer to the appendix for an example) or bridge the two interfaces (wireless and wired) on the computer. 3. Set the wireless station’s IP address to be in the same subnet as the computer in which the Wireless LAN USB Adapter is installed. 4.1 Swith to AP Mode Select “Access Point” from Mode(M) tab to make the Wireless LAN USB adapter act as a wireless AP. After you select “Access Point” mode, the Wireless LAN USB adapter available options will change. You will see the basic configuration menu of the AP function: 4.2 General SSID: The SSID is the uniqure name shared among all points in your wireless network. The name must be identical for all devices and points attempting to connect to the same network. It shows the current SSID setting of the Wireless USB adapter. BSSID: It shows the current BSSID’s MAC address. AID: Raise value by current connection. MAC Address: The station MAC address of current connection Life Time: The status of current connection. 4.3 Advanced Beacon Interval: The time between two beacons. (The system default is 100 ms.) DTIM Period: DTIM is a countdown informing clients of the next window for listening to broadcast and multicast messages. 3 is the default setting. Preamble Mode: This function will show up when Ad-hoc network type be selected. A preamble is a signal used in wireless environment to synchronize the transmitting timing including Synchronization and Start frame delimiter. Select from the pull-down menu to change the Preamble type into Long or Short. 4.4 Statistics If you want to know detailed information about how your software access point works, you can view the statistics of the access point. You can click “Reset” button to reset all counters to zero. 4.5 ICS The Internet Connection Sharing (ICS) function allows wireless clients to share a single internet connection. In the setup, Wireless USB adapter automatically assigns a virtual IP address to each of the wireless clients. (Please make sure your local network connection is connecting.) ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :