Évaluations - 3, GPA: 4
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
Drain plug (@) to pull out the hose. Open the pump filter to remove whatever any threads or objects. Be careful when draining if the water is hot. 2. Unplug the drain plug (@), allowing 3. Remove any foreign material from the water to flow out. At this time use a vessel to prevent water flowing on to the floor. When water does not flow any more, turn the pump filter (@) open to the left. the pump filter ((H)). After cleaning, turn the pump filter (®) clockwise and insert the drain plug (®) to the original place. Close the lower cover cap. ■ Cold condition If the washer is stored in an area where freezing may occur or moved in freezing temperatures, follow these instructions to prevent damage to the washer: 1. Turn offwater supply tap. 2. Disconnect hoses from water supply and drain water from hoses. 3. Plug electrical cord into a properly grounded electrical outlet. 4. Add 1gallon(3.8L) of nontoxic recreational vehicle (RV) antifreeze into an empty wash drum. Close the door. 5. Set spin cycle and let washer spin for 1 minute to drain out all water. Not all of the RV antifreeze will be expelled. 6. Unplug electrical power cord, dry the drum interior, and close the door. 7. Remove dispenser drawer, drain and dry excessive water from the compartments. 8. Store washer in an upright position. 9. To remove antifreeze from washer after storage, run empty washer through a complete cycle using detergent. Do not add wash load. El aintenance ■ Dispenser drawer ■5^ After a while detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water. • If necessary it can be removed completely from the machine by pressing the catch downwards and by pulling it out. • To facilitate cleaning, the upper part of the fabric softener compartment can be removed. ■ The drawer recess $ Detergent can also accumulate Inside the recess which should be cleaned occasionally. • Once you have finished cleaning, replace the drawer and run a rinse cycle without laundry. ■ The washing drum • If you live in a hard water area, limescale may continuously build up in places where it cannot be seen and thus not easily removed. • Over time the build up of scale clogs appliances, and if it Is not kept in check these may have to be replaced. • Although the washing drum Is made of Stainless steel, specks of rust can be caused by small metal articles (paper clips, safety pins) which have been left in the drum. • The washing drum should be cleaned from time to time. • If you use descaling agents, dyes or bleaches, make sure they are suitable for washing machine use. & Descaler may contain chemicals that may damage part of your washing machine. • Remove any spots with a stainless steel cleaning agent. $ Never use steel wool. ■ Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent. Immediately wipe off any spills. Wipe with damp cloth. Try not to hit surface with sharp objects. A WARNINGS Do not use methylated spirits, diluents or similar products. 2. Interior Dry around the washer door opening, flexible gasket and door glass. Run washer through a complete cycle using hot water. Repeat process if necessary. i?l% Remove hard water deposits using only cleaners labeled as safe for washing machine. 27 roubleshooting guide & This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately When the machine does not function properly or does not function at all, check the following points before you contact your service provider. Symptom Possible Cause Solution Rattling and clanking noise • Foreign objects such as coins or safety pins maybe in drum or pump. Stop washer and check drum and drain filter. If noise continues after washer is restarted, call your authorised service centre. Thumping sound • Heavy wash loads may produce a thumping sound. This is usually normal. If sound continues, washer is probably out of balance. Stop and redistribute wash load. Vibrating noise • Have all the transit bolts and packing been removed? • Are all the feet resting firmly on the ground? • Wash load may be unevenly distributed in drum. If not removed during installation. Refer to Installation guide for removing transit bolts. Adjusting washing horizontal level. Stop washer and rearrange wash load. Water leaks Oversudsing • Fill hoses or drain hose are loose at tap or washer. • House drain pipes are clogged. Too much detergent or unsuitable detergent may cause excessive foaming which may result in water leaks. Check and tighten hose connections. Unclog drain pipe. Contact plumber if necessary. It is necessary to decrease the quantity of detergent. The type of detergent should match the washing machine type. Oversudsing may provoke water leaking. Water does ...