For discoloration of an entire load, use phosphate detergent and Rust, brown or yellow nonchlorine bleach. Do not use chlorine bleach because it may intensify discoloration. discoloration LIQUID: Pretreat with a paste of granular detergent and water. PASTE: Scrape residue from fabric. Pretreat Shoe polish with prewash stain remover or nonflammable dry cleaning fluid. Rinse. Rub detergent into dampened area. Wash using bleach safe for fabric. Pretreat or soak in product containing enzymes. Wash u

If the washer serial number is below XC703, proceed with instructions 10 through 12. 10. In slot number 2, insert a small wire (paper clip) between the locking tab of the red wire terminal and the housing. Note: The locking tab is located in the small rectangular slot below the terminal. DO NOT push down on the contact prongs on the wire terminal. 11. Pull the red wire out of the slot. 12. Insert the red wire into slot number 4 until the terminal clicks into the housing. Gently pull on the wi

Wipe tub with a nonabrasive household cleanser, then rinse. Shake or brush excess dirt and sand from items before washing. Wash load too wet after spin. Washer is overloaded. Do not overload washer. See Washing Procedures. Load is out of balance. Rearrange load to allow proper spinning. Drain hose is kinked. Straighten drain hose. Water does not enter washer or it enters slowly. Water supply is not adequate in area. Check another faucet in the house. Wait until water supply and pressure increase

This will simplify the installation and ensure the laundry center is installed correctly and safely. Leave these instructions near the laundry center after installation for future reference. NOTE: The electrical service to the laundry center must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70, or in Canada, the Canadian Electrical Code, CSA C22.1 NOTE: The gas service to the laundry center must conform with local codes and ordinances

27” (69 cm) WideLAUNDRY CENTER Washer -Dryer Installation Instructions CENTRO DE LAVANDERIA de 27" (69 cm) de anchoLavadora -Secadora Instrucciones para la instalacion Table Of Contents SUBJECT PAGE Pre-Installation Requirements...............................2 Electrical Requirements..........................................3 Water Supply Requirements ....................................3 Drain Requirements.................................................3 Exhaust System Requirements ...........

outward 4. Install 2 screws through each rear bracket into aligning pedestal holes. Dryer cabinet (style 2) with 2 indents on side and 4 inch knockout for side venting. 5.8 cu ft DRYER (STYLE 2) INSTRUCTIONS (GREEN KIT) NO spacers under front brackets. “B” tab front slot - EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the dryer. TIP DOWN SLIDE BACK ENGAGE REAR TABS • GREEN KIT • GREEN KIT • GREEN KIT • GREEN KIT • GREEN KIT • 6 • WHITE KIT • WHIT

The cycle signal will sound briefly every 5 minutes as a reminder to remove the load. Automatic Regular Cycle This cycle is best for cotton items that can be tumble dried. Drying time is determined automatically at the temperature selection of your choice. This cycle is best for items of similar fabric, weight and construction. • For items requiring more drying time, set cycle selector on MORE DRY. • For items requiring less drying time, set cycle selector on LESS DRY. Timed Dry Cycle This cycle

27” (69 cm) WideLAUNDRY CENTER Washer -Dryer Use and Care Guide CENTRO DE LAVANDERIA de 27" (69 cm) de anchoLavadora -Secadora Manual de Uso y Cuidado P/N 137232600A (0906) TABLE OF CONTENTS Important Safety Instructions.................................................................................................................................2-4 Washing Procedures.................................................................................................................................

• A suitable drying temperature, dryness level and options will automatically be indicated for the cycle selected. See the “Dryer Settings Chart” for more details. • To change the drying temperature and dryness level, press the Temp or Dry Level buttons to scroll to the desired settings. • To select or delete an option, press Options; then, while the indicator is blinking, press Select. The indicator will light when the option has been selected. It will no longer be lighted when the option has b