Évaluations - 5, GPA: 4.2
(
)
)
|
Facilité d'utilisation
Tighten the screw. •Repeat this procedure to fasten the other frame back leg to the other side of the back base. Hint: The #10 x 2,2 cm black screws may have been assembled to the screw retainers. Frame Decorated Side Frame Back Legs Back Base Screw Retainers 8 •While pressing the levers on the seat height adjusters, lift them to position 4 on the frame front legs, as shown. Seat Height Adjusters Position Press Lever 9 •Fit the seat assembly between the two frames. •Insert the seat bottom tubes into the sockets in each seat height adjuster. Hints: •Be sure the seat height adjusters are in the same position (position 4). •You may need to push the frames apart slightly to fit the seat bottom tubes into the seat height adjuster sockets. Seat Assembly Sockets Seat Bottom Tubes 410 Assembly • Fit the frame front legs onto the front base. • Fit a screw retainer over the hole in a front leg. • Insert a #10 x 2,2 cm black screw through the screw retainer and front leg. Tighten the screw. • Repeat this procedure to fasten the other end of the front base with the remaining screw retainer and #10 x 2,2 cm black screw. Hint: The #10 x 2,2 cm black screws may have been assembled to the screw retainers. Front Base Screw Retainers Seat Height Adjusters • From the back and bottom of the assembly, insert a #8 x 1,9 cm screw through both seat height adjusters and the ends of the seat bottom tube. Tighten the screws. This may require extra force. Seat Bottom Tube Ends 13 • Squeeze the restraint release tabs together. • Remove the ends of the restraint system from the peg. PRESS 14 11 Push Push • Push each seat height adjuster to be sure they are completely on the seat bottom tubes. • Insert a #8 x 1,9 cm screw through each seat height adjuster and the ends of the seat bottom tube. Tighten the screws. This may require extra force. PRESS 12 Assembly • Remove both shoulder straps from the seat back. • Remove the crotch strap from the seat back. Shoulder Straps Crotch Strap 15 • Fit the pocket on the top of the pad onto the seat back. 16 Assembly • From behind the product, attach the end of the crotch strap to the peg. 20 Clips • Fit the clips on the front edge of the pad onto the seat bottom. • Hook the elastic loops on each side of the pad onto the tabs in the seat back. 17 18 Shoulder Straps Up Crotch Strap Down Lowest Slot Hint: Do not unbuckle the restraint system. It is easier to attach or re-attach it to the product if it is buckled. • Grasp the restraint system so that the shoulder straps are up and the crotch strap is down. • Insert the end of the crotch strap through the lowest slot in the pad and the seat back. • From behind the product, attach the end of the crotch strap to the peg. 19 10 Smaller Baby • Insert the ends of the shoulder straps through the lower slots in the pad. • From behind the product, attach the ends of the shoulder straps to the peg. Assembly Larger Baby • From the front of the product, insert the ends of the shoulder straps through the upper slots in the pad and seat back. • From behind the product, attach the ends of the shoulder straps to the peg. 21 22 11 Prevent serious injury or death from falls or sliding out: Alwaysusetherestraintsystemfortheuprightandreclinedpositionsoftheseat.Adjustrestrainttofityourchildsnugly.Thetrayisnotdesignedtoholdthechildinthechair. WARNING Secure Child 1 •Place your child in the seat. Position the crotch belt between your child’s legs. •Fasten both waist/shoulder belts to each side of the crotch belt. Make sure you hear a "click" on both sides. •Check to be sure the restraint system is securely attached by pulling it away from your child.The restraint system should remain attached. Waist/Shoulder Belt Waist/Shoulder Belt Crotch Belt •To tighten the waist straps: Feed the anchored end of the waist strap up through the buckle to form a loop .. Pull the free end of the waist strap .. •To tighten the shoulder straps: Hold the adjuster and pull the shoulder strap down C. Free End Anchored End Adjuster TIGHTEN 3 •To loosen the waist straps: Feed the free end of the waist strap up through the buckle to form a loop .. Enlarge the loop by pulling on the end of the loop toward the buckle. Pull the anchored end of the waist strap to shorten the free end of the waist strap .. •To loosen the shoulder straps: Lift the adjuster C. Note: After adjusting the restraint system to fit your child, make sure you pull on it to be sure it is securely fastened. Free End Anchored End Adjuster LOOSEN Shoulder Strap Shoulder Strap 11 Prevent serious injury or death from falls or sliding out: Alwaysusetherestraintsystemfortheuprightandreclinedpositionsoftheseat.Adjustrestrainttofityourchildsnugly.Thetrayisnotdesignedtoholdthechildinthechair. WARNING Secure Child 1 •Place your child in the seat. Position the crotch belt between your child’s legs. •Fasten both waist/shoulder belts to each side of the crotch belt. Make sure you hear a "click" on both sides. •Check to be sure the restraint system...