Évaluations - 3, GPA: 5
(
)
)
|
Facilité d'utilisation
gas service without converting the gas valve. An L.P. Conversion Kit must be installed by a qualified gas technician. 1. Remove the shipping cap from gas pipe at the rear of the dryer. 2. Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved pipe from gas supply line to the 3/8 inch (0.96cm) pipe located on the back of the dryer. Use a 1/2 inch to 3/8 inch (1.27 cm to 0.96cm) reducer for a connection. Apply an approved thread sealer that is resistant to the corrosive action of liquified gases on all pipe connections. 3. Open the shutoff valve in the gas supply line. 4. Test all connections by brushing on a soapy water solution. NEVER TEST FOR GAS LEAKS WITH AN OPEN FLAME. 5. Connect the exhaust duct to the outside exhaust system. Use duct tape to seal all joints. 6. With the dryer in its final position, adjust one or more of the legs until the dryer is resting solid on all four legs. Place a level on top of the dryer. THE DRYER MUST BE LEVEL AND RESTING SOLID ON ALL FOUR LEGS. 7. Plug the power cord into a grounded outlet. NOTE: check to ensure power is OFF at circuit breaker/fuse box before plugging the power cord into the outlet. 8. Turn on the power at the circuit breaker/fuse box. Before operating the dryer, make sure the dryer area is clean and free from combustible materials, gasoline, and other flammable vapors. Also see that nothing (such as boxes, clothing, etc.) obstructs the flow of combustion and ventilation air through the louvered panel located on the rear of the dryer. 9. Run the dryer through a cycle check for proper operation. NOTE: On gas dryers, before the burner will light, it is necessary for the gas line to be bled of air. If the burner does not light within 45 seconds the first time the dryer is turned on, the safety switch will shut the burner off. If this happens, turn the dryer to "OFF” and wait 5 minutes before making another attempt to light. NOTE: Follow instructons supplied with kit. 17 A CAUTION English CONNECTING THE DRYER TO THE GAS SUPPLY A) Connect female 3/8” NPT elbow to gas inlet on dryer. Then connect 3/8” flare union adapter to female elbow. IMPORTANT: To prevent the inlet from twisting, please use a pipe wrench to secure the dryer gas inlet. Affix Teflon® tape or pipe compound to adapter and gas inlet. B) Attach the flexible metal gas line connector to the adapter. C) Make sure flexible gas line seal is secure. Use two wrenches for the best possible connection. D) To check gas inlet pressure, attach 1/8” NPT plugged tapping to dryer gas line shut-off valve. Then connect flare union adapter to plugged tapping. Affix Teflon® tape to the threads of the adapter and plugged tapping to ensure seal. E) Use two adjustable wrenches to tighten every connection. IMPORTANT: Do not overtighten! F) Open gas shut-off valve. 18 English REPLACEMEN TPARTS Replacement parts and accessories for US and Canada can be purchased through Haier America at 1-800-313-8495 Label all wires prior to dis...
Ce manuel est également adapté pour les modèles :Séchoirs - CHDE5000AW (3.01 mb)
Séchoirs - CHDE5300AW (3.01 mb)
Séchoirs - HDE5000AW (3.01 mb)
Séchoirs - CHDE5000AW (3.01 mb)