Évaluations - 4, GPA: 4
(
)
)
|
Facilité d'utilisation
9-11 Pre-installation Requirements ................................................2 Reversing door ....................................................................12 Installation Requirements ..................................................3-7 Accessories/Replacement parts ............................................12 Installed Dimensions .............................................................8 Espanol ...............................................................................13 Important Safety Instructions For your safety the information in this manual must be followed to minimize the risk of fi re or explosion or to prevent property damage, personal injury or loss of life. Do not store or use gasoline or other fl ammable vapors and liquids in the vicinity of this or any other appliance. This symbol alerts you to situations that Recognize safety symbols, words and labels may cause serious body harm, death or Safety items throughout this manual are labeled with a property damage. WARNING or CAUTION based on the risk type as described: This symbol alerts you to situations that may cause bodily injury or property damage. -RISK OF FIRE - Read all of the following instructions before installing and using this appliance: • Destroy the carton and plastic bags after the dryer is unpacked. Children might use them for play. Cartons covered with rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. Place all materials in a garbage container or make materials inaccessible to children. • Clothes dryer installation and service must be performed by a qualifi ed installer, service agency or the gas supplier. • Install the clothes dryer according to the manufacturer’s instructions and local codes. • The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70, or in Canada, the Canadian electrical code C22.1 part 1. • The gas service to the dryer must conform with local codes and ordinances and the latest edition of the National Fuel Gas Code ANSI Z223.1, or in Canada, CAN/ACG B149.1-2000. • The dryer is designed under ANSI Z 21.5.1 or ANSI/UL 2158 - CAN/CSA C22.2 No. 112 (latest editions) for HOME USE only. This dryer is not recommended for commercial applications such as restaurants, beauty salons, etc. • Do not install a clothes dryer with fl exible plastic venting material. Flexible venting materials are known to collapse, be easily crushed and trap lint. These conditions will obstruct clothes dryer airfl ow and increase the risk of fi re. • The instructions in this manual and all other literature included with this dryer are not meant to cover every possible condition and situation that may occur. Good safe practice and caution MUST be applied when installing, operating and maintaining any appliance. WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Clear the room, building or area of all occupants. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fi re department. Save these instructions for future reference. Pre-Installation Requirements Tools and materials needed for installation: • Adjustable pliers • Carpenter’s level • Gas line shutoff valve (gas dryer) • Phillips, straight, & square bit screw• External vent hood • . NPT union fl are adapters (x2) and drivers • 4-inch (10.2 cm), rigid metal or semifl exible gas supply line (gas dryer) • Adjustable wrench rigid metal exhaust duct work • Metal foil tape (not duct tape) • Pipe wrench for gas supply (gas dryer) • 3-wire or 4-wire 240 volt cord kit • LP-resistant thread tape (for natural (electric dryer) gas or LP supply, gas dryer) • 4 in. (10.2 cm) clamp 2 Electrical System Requirements Because of potentially inconsistent voltage capabilities, the use of this dryer with power created by gas powered generators, solar powered generators, wind powered generators or any other generator other than the local utility company is not recommended. Electrical requirements for electric dryer CIRCUIT - Individual 30 amp. branch circuit fused with 30 amp. time delay fuses or circuit breakers. Use separately fused circuits for washer and dryer. DO NOT operate a washer and a dryer on the same circuit. POWER SUPPLY - 3-wire or 4-wire, 240 volt, single phase, 60 Hz, Alternating Current. This dryer is internally grounded to neutral unless it was manufactured for sale in Canada. Grounding through the neutral link is prohibited for: (1) new branch circuit installations, (2) mobile homes, (3) recreational vehicles, and (4) areas where local codes do not permit grounding through the neutral. OUTLET RECEPTACLE - NEMA 10-30R or NEMA 14-30R receptacle to be located so the power supply cord is accessible when the dryer is in the installed position. GROUNDING C...