Évaluations - 2, GPA: 3.5 ( )

Fabricant : American Dryer Corp. Taille : 1.42 mb Nom Fichier : 917420EN.pdf Langue d'enseignement:

To clean the condenser: 1. Open the loading door. 2. Move the release button on the bottom of the door opening and open the condenser door. 3. Turn the 2 blockages to unlock the condenser lid. 4. Lower the condenser lid. 5. Catch the handle and pull the condenser out from the bottom compartment. Move condenser horizontally to do not spill remaining water. 6. Clean the condenser in vertical position over a basin or paddling. Rinse through with a hand shower. 7. Clean the condenser filter. Rinse through with a hand shower. 8. Put the condenser back inside the bottom compartment. 9. Close the condenser lid. 10. Lock the 2 blockages until they snap. 11. Close the condenser door. CAUTION! Do not operate the tumble dryer when the condenser is blocked with fluff. This could cause the damage to the tumble dryer. This also increases energy consumption. Do not use sharp objects to clean the condenser. The damaged condenser could cause leaks. Do not operate the tumble dryer without the condenser. CLEANING THE DRUM WARNING! Disconnect the appliance before you clean it. Use a standard neutral soap detergent to clean the inner surface of the drum and drum ribs. Dry the cleaned surfaces with a soft cloth. ENGLISH 17 18 CAUTION! Do not use abrasive materials or steel wool to clean the drum. CLEANING THE CONTROL PANEL AND HOUSING Use a standard neutral soap detergent to clean the control panel and housing. Use a moist cloth to clean. Dry the cleaned surfaces with a soft cloth. CAUTION! Do not use furniture cleaning agents or cleaning agents which can cause corrosion to clean the appliance. on the display. ENGLISH 19 TROUBLESHOOTING TROUBLESHOOTING Problem1) Possible cause Remedy The tumble dryer is not connected to mains supply. Connect in at mains socket. Check fuse in fuse box (domestic installation). The tumble dryer does not operate. The loading door is opened. The On/Off button was not pushed. The Start/Pause button was not pushed. Close the loading door. Push the On/Off button. Push the Start/Pause button. The appliance is in the standby mode. Push the On/Off button. Incorrect programme selection. Do the selection of the applicable programme. 2) The filter is clogged. Clean the filter. 3) Unsatisfactory drying results. The condenser is clogged. Too high volume of the load. The airflow grill is clogged. Clean the condenser. 3) Obey the maximum load volume. Clean the airflow grill in the bottom of the appliance. Dirt on the inner surface of the drum. Clean the inner surface of the drum. Too high water hardness. Set applicable water hardness4). The door does not close. The filter not locked in the position. The laundry is locked between the door and the seal. Put the filter in the correct position. Put the load correctly in the drum. Err (Error) You try to change the programme or the function after the start of the cycle. Turn the tumble dryer off and on. Make the new selection. The function you try to activate Turn the tumble dryer off and is not applicable with the selec on. Make the new selection. ted programme. Abnormally The time to end is calculated on elapsing The automatic procedure — this the basis of the volume and time on the is not the appliance malfunction. dampness of the laundry. display.) Programme Drain the water container3) , The water container is full. inactive. push the Start/Pause button. 20 Drying cycle too short. To small laundry volume. The laundry is too much dried. Do the selection of time programme. Do the selection of time programme or higher drying level (e.g. Extra Dry ) The filter is clogged. Clean the filter. Drying cycle too long 5) Too high volume of the load. The laundry not spun sufficiently. Obey the maximum load volume. Spin correctly the laundry. Very high room temperature this is not the appliance malfunction. If possible, lower the room temperature. 1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Make a selection of the new programme. Push the Start/Pause button. Does not operate? contact the service centre and give the error code. 2) follow the programme description — see PROGRAMMES chapter 3) see CARE AND CLEANING chapter 4) see section WATER HARDNESS in HINTS AND TIPS chapter 5) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle complete section). ENGLISH 21 TECHNICAL INFORMATION height x width x depth 850 x 600 x 600 mm (maximal 640 mm) drum volume 118 l maximum depth with the load door 1090 mm opened maximum width with the load door 950 mm opened adjustable height 850 mm (+ 15 mm - feet regulation) the appliance weight 41 kg maximum load volume 7 kg voltage 230-240 V frequency 50 Hz necessary fuse 13 A total power 2800 W energy efficiency class B energy consumption kWh/cycle 1) 3,92 kWh annual energy consumption2) 284,1 kWh type of use Domestic permitted ambient temperature + 5°C to + 35°C 1) 7 kg of cotton, centrifuged at 1000 rpm with reference to EN 61121 2) The sum of appr...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :