Évaluations - 2, GPA: 4.5
(
)
)
|
Facilité d'utilisation
• Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. • Do not install the appliance on deep pile carpet. • This tumble dryer is designed to be vented through to the open air. It should have its own ventilation system which should not be joined with any other ventilation system connected to any other appliance. • The dryer must not be vented into a chimney, or flue pipe designed to carry the exhaust from a fuel burning heating appliance. • If the tumble dryer is installed next to a fuel burning stove, a heat insulation non-flammable pad must be inserted between the fuel burning stove and the tumble dryer: (dimensions 85 x 57 cm). • If the dryer is installed in a room with a fuel burning heating appliance, consult your local Corgi registered installer. • The tumble dryer should not be installed in situations which may be subject to freezing temperatures. • The installation site must be well ventilated. • Ensure the appliance does not stand on the electrical supply cable. • If the machine is situated on carpeted floor, please adjust the feet in order to allow air to circulate freely. • The tumble dryer must be level. • Observe the safety precautions in the operating instructions for your dryer. • Air is drawn in through vents at the rear and front of this appliance. Therefore, keep the area around the appliance clear. Technical data Technical data Height x Width x Depth 85x60x60cm Depth with the door open 117cm Height adjustable from 1.0/–0.4cm Empty weight approx. 40kg Load (depending on the program) max. 5kg Power consumption in acc. with IEC 1121 s.e. 3.4kWh (5 kg Cotton, spun at 800 revolutions per minute) Area of use Household Permissible ambient temperature +5°C up to +35°C ; This appliance complies with the following EC directives: – 73/23/EEC of 19/2/1973 ’Low voltage directive’ – 89/336/EEC of 3/5/1989 ’EMC directive’ including the Modification directive 92/31/EEC Electrical Connection 9 Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. 1 WARNING - THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is located inside the door. The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1362) fuse must be used. Should the plug need to be replaced for any reason. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow : Earth Blue : Neutral Brown : Live Blue Green & Yellow Brown Cord Clamp Electrical Connection • The wire coloured green and yellow must be connected to the terminal marked with the letter “E“ or by the earth symbol or coloured green and yellow • The wire coloured blue must be connected to the terminal “N“ or coloured black. • The wire coloured brown must be connected to the terminal marked “L“ or coloured red. • Upon completion there must not be cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. 1 WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely. Permanent connection In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. Site Preparation Site Preparation • The installation surface must be clean and dry. • Do not install on a deep pile carpet. • If the appliance is installed next to a heat source (e. g. cooking appliance), a heat insulation pad (85 x 57 cm) must be placed between the washing machine and the heat source. • Do not install the appliance where the temperature may fall below freezing or rise above 35°C. • Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. Levelling the Appliance The appliance must be levelled using the adjustable feet. Use a screwdriver to adjust to the feet until the appliance is level. Venting Venting The appliance expels hot, moist air which must be able to flow freely from the tumble dryer vent. Tumble Dryer Vents View from left Rear view View from right The most efficient way of venting the expelled air is via a vent hose through to the outside. Venting Venting through a Vent Hose The vent hose expelling the hot air should be 100 mm diameter and no longer than 4 meters. Avoid bends in the vent hose as this will reduce the air flow. The maximum len...
Ce manuel est également adapté pour les modèles :Séchoirs - LAVATHERM 35600 (498.82 kb)
Séchoirs - LAVATHERM 35600 (498.82 kb)
Séchoirs - LAVATHERM 35600 (498.82 kb)